[OpenWrt-Devel] Chaos Calmer 15.05-rc2

[Fernando Frediani]

Anyone ? I am still investigating this issue and trying to figure out if 
it's a Openwrt or ISP problem.

Would that changelog have anything to do with this ?

Fernando

On 13/06/2015 12:43, Fernando Frediani wrote:
> Hi folks,
>
> I'm seeing an issue on my Barrier Breaker running on a TP-Link WR842ND 
> where it gets an IPv6 /128 to the WAN interface + /64 on the LAN 
> interface via DHCPv6 + PD, however it does NOT set the default gateway 
> by default, so I have to discover it and set manually using the 
> other-side link-local.
> Even though eventually while running and after a few "Save & Apply" it 
> "mysteriously" looses the same default gateway I have set manually 
> (I'm guessing due DHCPv6 changing it every in a while to the original 
> when it booted - none). And it can't ping it anymore (the other-side 
> link local address). By the way, it's a cable connection.
>
> For comparison I have another router running DD-WRT from 22/Nov/2014 
> connected to the same ISP in another point of the city and it works 
> fine DHCPv6, sets the default gateway by default and never looses it.
>
> By any chance this changelog "/Fixed broken IPv6 downstream DHCPv6-PD 
> and onlink-route handling/" would perhaps have anything to do with 
> that problem observed ?
>
> Thanks
> Fernando
>
>
> On 13/06/2015 11:21, Steven Barth wrote:
>> The OpenWrt developers are proud to announce the first release candidate
>> of OpenWrt Chaos Calmer.
>>
>>     _______                     ________        __
>>   |       |.-----.-----.-----.|  |  |  |.----.|  |_
>>   |   -   ||  _  |  -__|     ||  |  |  ||   _||   _|
>>   |_______||   __|_____|__|__||________||__|  |____|
>>            |__| W I R E L E S S   F R E E D O M
>>   -----------------------------------------------------
>>   CHAOS CALMER (15.05 RC2)
>>   -----------------------------------------------------
>>    * 1 1/2 oz Gin            Shake with a glassful
>>    * 1/4 oz Triple Sec       of broken ice and pour
>>    * 3/4 oz Lime Juice       unstrained into a goblet.
>>    * 1 1/2 oz Orange Juice
>>    * 1 tsp. Grenadine Syrup
>>   -----------------------------------------------------
>>
>>   -----------------------------------------------------
>> http://downloads.openwrt.org/chaos_calmer/15.05-rc2/
>>
>> ** Improvements since RC 1 **
>> * Fixed broken ImageBuilders for most targets
>> * Updated 3.18 to 3.18.14
>> * Fixed broken IPv6 downstream DHCPv6-PD and onlink-route handling
>> * Images (special format) for Asus brcm47xx and bcm53xx devices
>> * Improved stability of sysupgrade on brcm47xx and bcm53xx
>> * Added HTTPS enforcement option to uhttpd
>> * Fixed umask issue
>> * Added support for a few new boards
>>
>>
>> ** Highlights since Barrier Breaker **
>>
>> * Linux kernel updated to version 3.18
>> * Improved Security Features
>>      - Rewritten package signing architecture based on ed25519
>>      - Added support for jails
>>      - Added support for hardened builds
>> * Improved Networking Support
>>      - Added or improved support for lots of 3G/4G modems (MBIM, QMI,
>> NCM, ...)
>>      - Added support for 464XLAT (CLAT) [RFC 6877 + RFC 7050]
>>      - Netfilter performance enhancements (conntrack route cache)
>>      - Improved support for self-managing networks [draft-ietf-homenet-hncp]
>>      - Better multi-core support for the network stack
>>      - Improved support for MAP-E, MAP-T and LW4over6 IPv4 transitioning
>> technologies
>>          [draft-ietf-softwire-map, -map-t, -map-dhcp, -lw4over6]
>>      - Improved network auto-setup capable of detecting and bootstrapping
>> IPv4-only,
>>        6rd, Dual-Stack, IPv6-only, DS-Lite, LW4over6, MAP-E, MAP-T, 464XLAT
>>        and combinations without explicit configuration [based on RFC 7084]
>>      - Added support for Smart Queue Management (SQM) QoS, AQM and
>> Traffic Shaping
>>      - Improved support for DNSSEC
>> * Platform and Driver Support
>>      - Added support for feeds of externally maintained targets
>>      - New mt7621 subtarget for Mediatek 11ac SoC
>>      - New mt76 mac80211 based wifi driver for MTK 11ac cores.
>>      - New mwlwifi mac80211 based wifi driver for the Marvell 88W8864
>>      - New bcm53xx target for Broadcom ARM BCM47xx/53xx devices
>>      - New mxs target for Freescale i.MX23/28 family and various boards
>>      - New sunxi target for AllWinner A10/A13/A20 family and various boards
>>      - brcm2708: support for Raspberry Pi 2
>>      - brcm63xx: support for BCM6318 and BCM63268 family
>>      - brcm63xx: improved fallback sprom support with bcma support
>>
>> * Known Issues
>>      - Sysupgrade on brcm47xx may fail by running out of memory when
>> using .bin or .chk files. Please use .trx when using rc1 (it was fixed
>> in rc2).
>>       - openssl and strongswan are outdated. If you intend to use either
>> of them please update the packages using the snapshots repository:
>> https://downloads.openwrt.org/snapshots/trunk/
>>
>>
>> And lots and lots of other advancements...
>> As always a big thank you goes to all our active package maintainers,
>> testers, supporters and documenters.
>>
>>
>> Have fun!
>>      The OpenWrt developer team
>> _______________________________________________
>> openwrt-devel mailing list
>> openwrt-devel at lists.openwrt.org
>> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.infradead.org/pipermail/openwrt-devel/attachments/20150617/be04b327/attachment.htm>
-------------- next part --------------
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel