[PATCH] ath79: add support for RouterBOARD mAP

Thibaut VARÈNE hacks at slashdirt.org
Wed May 4 05:32:28 PDT 2022 

The MikroTik mAP-2nd (sold as mAP) is an indoor 2.4Ghz AP with
802.3af/at PoE input and passive PoE passthrough.

See https://mikrotik.com/product/RBmAP2nD for more details.

Specifications:
 - SoC: QCA9533
 - RAM: 64MB
 - Storage: 16MB NOR
 - Wireless: QCA9533 802.11b/g/n 2x2
 - Ethernet: 2x 10/100 ports,
    802.3af/at PoE in port 1, 500 mA passive PoE out on port 2
 - 7 user-controllable LEDs

Note: the device is a tiny AP and does not distinguish between both
ethernet ports roles, so they are both assigned to lan.
With the current setup, ETH1 is connected to eth1 and ETH2 is connected
to eth0 via the embedded switch port 2.

Flashing:
 TFTP boot initramfs image and then perform sysupgrade. The "ETH1" port
 must be used to upload the TFTP image. Follow common MikroTik procedure
 as in https://openwrt.org/toh/mikrotik/common.

Tested-By: Andrew Powers-Holmes <aholmes at omnom.net>
Signed-off-by: Thibaut VARÈNE <hacks at slashdirt.org>
---
 .../qca9533_mikrotik_routerboard-map-2nd.dts  | 113 ++++++++++++++++++
 target/linux/ath79/image/mikrotik.mk          |   9 ++
 .../mikrotik/base-files/etc/board.d/01_leds   |   5 +
 .../base-files/etc/board.d/02_network         |   4 +
 .../etc/hotplug.d/firmware/10-ath9k-eeprom    |   3 +
 5 files changed, 134 insertions(+)
 create mode 100644 target/linux/ath79/dts/qca9533_mikrotik_routerboard-map-2nd.dts

diff --git a/target/linux/ath79/dts/qca9533_mikrotik_routerboard-map-2nd.dts b/target/linux/ath79/dts/qca9533_mikrotik_routerboard-map-2nd.dts
new file mode 100644
index 0000000000..25971e6f43
--- /dev/null
+++ b/target/linux/ath79/dts/qca9533_mikrotik_routerboard-map-2nd.dts
@@ -0,0 +1,113 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "qca9533_mikrotik_routerboard-16m.dtsi"
+
+/ {
+	compatible = "mikrotik,routerboard-map-2nd", "qca,qca9533";
+	model = "MikroTik RouterBOARD mAP-2nD (mAP)";
+
+	aliases {
+		led-boot = &led_user;
+		led-failsafe = &led_user;
+		led-running = &led_user;
+		led-upgrade = &led_user;
+	};
+
+	leds {
+		compatible = "gpio-leds";
+
+		power {
+			label = "green:power";
+			gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
+			default-state = "on";
+		};
+
+		eth_1 {
+			label = "green:eth_1";
+			gpios = <&gpio_ext 0 GPIO_ACTIVE_LOW>;
+		};
+
+		eth_2 {
+			label = "green:eth_2";
+			gpios = <&gpio_ext 1 GPIO_ACTIVE_LOW>;
+		};
+
+		poe_out {
+			label = "red:poe_out";
+			gpios = <&gpio_ext 2 GPIO_ACTIVE_LOW>;
+		};
+
+		led_user: user {
+			label = "green:user";
+			gpios = <&gpio_ext 3 GPIO_ACTIVE_LOW>;
+		};
+
+		wlan {
+			label = "green:wlan";
+			gpios = <&gpio_ext 4 GPIO_ACTIVE_LOW>;
+			linux,default-trigger = "phy0tpt";
+		};
+
+		ap_cap {
+			label = "green:ap_cap";
+			gpios = <&gpio_ext 6 GPIO_ACTIVE_LOW>;
+		};
+
+	};
+
+	gpio-export {
+		compatible = "gpio-export";
+
+		usb_power {
+			gpio-export,name = "usb-power";
+			gpio-export,output = <1>;
+			gpios = <&gpio_ext 5 GPIO_ACTIVE_LOW>;
+		};
+
+		enable_poe_port5 {
+			gpio-export,name = "enable-poe";
+			gpio-export,output = <0>;
+			gpios = <&gpio 14 GPIO_ACTIVE_HIGH>;
+		};
+	};
+};
+
+&spi {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pin_spi_cs1>;
+
+	gpio_ext: gpio_ext at 1 {
+		compatible = "fairchild,74hc595";
+		reg = <1>;
+		gpio-controller;
+		#gpio-cells = <2>;
+		registers-number = <1>;
+		spi-max-frequency = <25000000>;
+	};
+};
+
+
+&pinmux {
+	pin_spi_cs1: pinmux_spi_cs1 {
+		pinctrl-single,bits = <0x8 0x0a000000 0xff000000>;
+	};
+};
+
+&eth0 {
+	status = "okay";
+
+	phy-handle = <&swphy0>;
+
+	gmac-config {
+		device = <&gmac>;
+		switch-phy-swap = <1>;
+	};
+};
+
+&usb0 {
+	status = "okay";
+};
+
+&usb_phy {
+	status = "okay";
+};
diff --git a/target/linux/ath79/image/mikrotik.mk b/target/linux/ath79/image/mikrotik.mk
index 30c1761134..1c47b2ec5b 100644
--- a/target/linux/ath79/image/mikrotik.mk
+++ b/target/linux/ath79/image/mikrotik.mk
@@ -66,6 +66,15 @@ define Device/mikrotik_routerboard-lhg-5nd
 endef
 TARGET_DEVICES += mikrotik_routerboard-lhg-5nd
 
+define Device/mikrotik_routerboard-map-2nd
+  $(Device/mikrotik_nor)
+  SOC := qca9533
+  DEVICE_MODEL := RouterBOARD mAP-2nD (mAP)
+  DEVICE_PACKAGES += kmod-usb2 kmod-ledtrig-gpio
+  IMAGE_SIZE := 16256k
+endef
+TARGET_DEVICES += mikrotik_routerboard-map-2nd
+
 define Device/mikrotik_routerboard-mapl-2nd
   $(Device/mikrotik_nor)
   SOC := qca9533
diff --git a/target/linux/ath79/mikrotik/base-files/etc/board.d/01_leds b/target/linux/ath79/mikrotik/base-files/etc/board.d/01_leds
index f5b927ea96..77d7c37c97 100644
--- a/target/linux/ath79/mikrotik/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/mikrotik/base-files/etc/board.d/01_leds
@@ -20,6 +20,11 @@ mikrotik,routerboard-lhg-5nd)
 	ucidef_set_led_rssi "rssimediumhigh" "rssimediumhigh" "green:rssimediumhigh" "wlan0" "60" "100"
 	ucidef_set_led_rssi "rssihigh" "rssihigh" "green:rssihigh" "wlan0" "80" "100"
 	;;
+mikrotik,routerboard-map-2nd)
+	ucidef_set_led_netdev "eth_1" "eth_1" "green:eth_1" "eth1"
+	ucidef_set_led_switch "eth_2" "eth_2" "green:eth_2" "switch0" "0x4"
+	ucidef_set_led_gpio "poe" "poe" "red:poe_out" "14" "0"
+	;;
 mikrotik,routerboard-wapr-2nd)
 	ucidef_set_rssimon "wlan0" "200000" "1"
 	ucidef_set_led_rssi "rssilow" "rssilow" "green:rssilow" "wlan0" "1" "100"
diff --git a/target/linux/ath79/mikrotik/base-files/etc/board.d/02_network b/target/linux/ath79/mikrotik/base-files/etc/board.d/02_network
index 999ce0dd99..eb3534b896 100644
--- a/target/linux/ath79/mikrotik/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/mikrotik/base-files/etc/board.d/02_network
@@ -24,6 +24,9 @@ ath79_setup_interfaces()
 	mikrotik,routerboard-wapr-2nd)
 		ucidef_set_interface_lan "eth0"
 		;;
+	mikrotik,routerboard-map-2nd)
+		ucidef_set_interface_lan "eth0 eth1"
+		;;
 	mikrotik,routerboard-962uigs-5hact2hnt)
 		ucidef_add_switch "switch0" \
 			"0 at eth0" "2:lan" "3:lan" "4:lan" "5:lan" "1:wan"
@@ -46,6 +49,7 @@ ath79_setup_macs()
 	mikrotik,routerboard-912uag-2hpnd|\
 	mikrotik,routerboard-lhg-2nd|\
 	mikrotik,routerboard-lhg-5nd|\
+	mikrotik,routerboard-map-2nd|\
 	mikrotik,routerboard-mapl-2nd|\
 	mikrotik,routerboard-sxt-5nd-r2|\
 	mikrotik,routerboard-wap-2nd|\
diff --git a/target/linux/ath79/mikrotik/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/mikrotik/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
index 800ce11d51..51670ec92b 100644
--- a/target/linux/ath79/mikrotik/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
+++ b/target/linux/ath79/mikrotik/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
@@ -31,6 +31,9 @@ case "$FIRMWARE" in
 	mikrotik,routerboard-wapr-2nd)
 		caldata_mikrotik_ath9k 0x1000 0x440 $(macaddr_add "$mac_base" 1)
 		;;
+	mikrotik,routerboard-map-2nd)
+		caldata_mikrotik_ath9k 0x1000 0x440 $(macaddr_add "$mac_base" 3)
+		;;
 	mikrotik,routerboard-mapl-2nd|\
 	mikrotik,routerboard-wap-g-5hact2hnd)
 		caldata_mikrotik_ath9k 0x1000 0x440 $(macaddr_add "$mac_base" 2)
-- 
2.24.3 (Apple Git-128)

More information about the openwrt-devel mailing list