fix for lantiq (danube) usb

[Luca Olivetti]

El 5/7/20 a les 15:07, Luca Olivetti ha escrit:
> El 5/7/20 a les 13:59, Luca Olivetti ha escrit: escrit:
> 
>> I'm recompiling again in case I misplaced the section in my previous 
>> test. In ~30-40 minutes it should be ready and I'll report back.
> 
> Success!
> I probably did something wrong before.
> I'm attaching the patch against 19.07.3 and my device, but I think the 
> same should be done for trunk and other devices with a similar dts.

Now it would be nice to also remove these harmless warnings ("supply 
vusb_[da] not found" and "Mode Mismatch Interrupt"):


# dmesg | grep dwc2
[    5.769881] dwc2 1e101000.usb: 1e101000.usb supply vusb_d not found, 
using dummy regulator
[    5.776840] dwc2 1e101000.usb: 1e101000.usb supply vusb_a not found, 
using dummy regulator
[    5.784970] dwc2 1e101000.usb: dwc2_core_reset() HANG! Soft Reset 
GRSTCTL=80000001
[    5.930874] dwc2 1e101000.usb: DWC OTG Controller
[    5.934191] dwc2 1e101000.usb: new USB bus registered, assigned bus 
number 1
[    5.941041] dwc2 1e101000.usb: irq 62, io mem 0x1e101000
[  239.438602] dwc2 1e101000.usb: Mode Mismatch Interrupt: currently in 
Host mode
[  239.444386] dwc2 1e101000.usb: Mode Mismatch Interrupt: currently in 
Host mode
[  239.638464] usb 1-1: new high-speed USB device number 2 using dwc2
[  239.643522] dwc2 1e101000.usb: Mode Mismatch Interrupt: currently in 
Host mode
[  239.650233] dwc2 1e101000.usb: Mode Mismatch Interrupt: currently in 
Host mode


but I'm happy enough that this is fixed now.
Any chance of having a working rtl8812au driver? ;-)


Bye
-- 
Luca