[OpenWrt-Devel] [PATCH] Add support for PandoraBox PBR-M1 Board
Tymon
banglang.huang at foxmail.com
Tue Jun 16 03:27:34 EDT 2015
Hi all,
please find below patch that adds support for PandoraBox PBR-M1 Board
to OpenWRT trunk.
The board is based on mt7621 platform, and this patch
adds a separate profile for pbr-m1.
Best regards,
Tymon
From: tymon <tymon at xcloud.cc>
Signed-off-by: tymon <tymon at xcloud.cc>
---
target/linux/ramips/base-files/etc/board.d/01_leds | 5 +
.../linux/ramips/base-files/etc/board.d/02_network | 1 +
target/linux/ramips/base-files/etc/diag.sh | 3 +
target/linux/ramips/base-files/lib/ramips.sh | 3 +
.../ramips/base-files/lib/upgrade/platform.sh | 1 +
target/linux/ramips/dts/PBR-M1.dts | 150 +++++++++++++++++++++
target/linux/ramips/image/Makefile | 7 +-
target/linux/ramips/mt7621/profiles/pbr-m1.mk | 22 +++
8 files changed, 191 insertions(+), 1 deletion(-)
create mode 100644 target/linux/ramips/dts/PBR-M1.dts
create mode 100644 target/linux/ramips/mt7621/profiles/pbr-m1.mk
diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds
index ad0062a..c63ff47 100755
--- a/target/linux/ramips/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/base-files/etc/board.d/01_leds
@@ -175,6 +175,11 @@ case $board in
set_wifi_led "7links:orange:wifi"
set_usb_led "7links:blue:storage"
;;
+ pbr-m1)
+ ucidef_set_led_netdev "internet" "internet" "pbr-m1:green:internet" "eth0.2"
+ ucidef_set_led_default "power" "power" "pbr-m1:green:power" "1"
+ ucidef_set_led_default "sys" "sys" "pbr-m1:green:sys" "1"
+ ;;
sl-r7205)
set_wifi_led "rt2800pci-phy0::radio"
;;
diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network
index 4982566..b3dd1f1 100755
--- a/target/linux/ramips/base-files/etc/board.d/02_network
+++ b/target/linux/ramips/base-files/etc/board.d/02_network
@@ -129,6 +129,7 @@ ramips_setup_interfaces()
dir-320-b1 | \
dir-615-h1 | \
firewrt | \
+ pbr-m1 | \
hlk-rm04 | \
mt7621 | \
mt7628 | \
diff --git a/target/linux/ramips/base-files/etc/diag.sh b/target/linux/ramips/base-files/etc/diag.sh
index d6001c5..bfc92e5 100644
--- a/target/linux/ramips/base-files/etc/diag.sh
+++ b/target/linux/ramips/base-files/etc/diag.sh
@@ -117,6 +117,9 @@ get_status_led() {
omni-emb-hpm)
status_led="emb:green:status"
;;
+ pbr-m1)
+ status_led="pbr-m1:green:sys"
+ ;;
psr-680w)
status_led="psr-680w:red:wan"
;;
diff --git a/target/linux/ramips/base-files/lib/ramips.sh b/target/linux/ramips/base-files/lib/ramips.sh
index 0cb02c7..14ffc21 100755
--- a/target/linux/ramips/base-files/lib/ramips.sh
+++ b/target/linux/ramips/base-files/lib/ramips.sh
@@ -247,6 +247,9 @@ ramips_board_detect() {
*"OLinuXino-RT5350F-EVB")
name="olinuxino-rt5350f-evb"
;;
+ *"PBR-M1")
+ name="pbr-m1"
+ ;;
*"Petatel PSR-680W"*)
name="psr-680w"
;;
diff --git a/target/linux/ramips/base-files/lib/upgrade/platform.sh b/target/linux/ramips/base-files/lib/upgrade/platform.sh
index 99cabbd..8d5f74f 100755
--- a/target/linux/ramips/base-files/lib/upgrade/platform.sh
+++ b/target/linux/ramips/base-files/lib/upgrade/platform.sh
@@ -53,6 +53,7 @@ platform_check_image() {
fonera20n | \
freestation5 | \
firewrt |\
+ pbr-m1 |\
hg255d | \
hlk-rm04 | \
ht-tm02 | \
diff --git a/target/linux/ramips/dts/PBR-M1.dts b/target/linux/ramips/dts/PBR-M1.dts
new file mode 100644
index 0000000..76eae93
--- /dev/null
+++ b/target/linux/ramips/dts/PBR-M1.dts
@@ -0,0 +1,150 @@
+/dts-v1/;
+
+/include/ "mt7621.dtsi"
+
+/ {
+ compatible = "mediatek,mt7621-eval-board", "mediatek,mt7621-soc";
+ model = "PBR-M1";
+
+ memory at 0 {
+ device_type = "memory";
+ reg = <0x0 0x10000000>;
+ };
+
+ chosen {
+ bootargs = "console=ttyS0,115200";
+ };
+
+ sdhci at 10130000 {
+ status = "okay";
+ };
+
+ palmbus at 1E000000 {
+ spi at b00 {
+ status = "okay";
+
+ m25p80 at 0 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "w25q256";
+ reg = <0 0>;
+ linux,modalias = "m25p80";
+ spi-max-frequency = <10000000>;
+
+ partition at 0 {
+ label = "u-boot";
+ reg = <0x0 0x30000>;
+ read-only;
+ };
+
+ partition at 30000 {
+ label = "u-boot-env";
+ reg = <0x30000 0x10000>;
+ read-only;
+ };
+
+ factory: partition at 40000 {
+ label = "factory";
+ reg = <0x40000 0x10000>;
+ read-only;
+ };
+
+ partition at 50000 {
+ label = "firmware";
+ reg = <0x50000 0xfb0000>;
+ };
+
+ };
+ };
+
+ i2c at 900 {
+ compatible = "ralink,i2c-mt7621";
+ reg = <0x900 0x100>;
+
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2c_pins>;
+
+ status = "okay";
+
+ pcf8563: rtc at 51 {
+ status = "okay";
+ compatible = "nxp,pcf8563";
+ reg = <0x51>;
+ };
+ };
+ };
+
+ pcie at 1e140000 {
+ status = "okay";
+
+ pcie0 {
+ mt76 at 0,0 {
+ reg = <0x0000 0 0 0 0>;
+ device_type = "pci";
+ mediatek,mtd-eeprom = <&factory 0x0000>;
+ mediatek,2ghz = <0>;
+ };
+ };
+
+ pcie1 {
+ mt76 at 1,0 {
+ reg = <0x0000 0 0 0 0>;
+ device_type = "pci";
+ mediatek,mtd-eeprom = <&factory 0x8000>;
+ mediatek,5ghz = <0>;
+ };
+ };
+ };
+
+ ethernet at 1e100000 {
+ mtd-mac-address = <&factory 0xe000>;
+ };
+
+ gpio-leds {
+ compatible = "gpio-leds";
+
+ buzzer {
+ label = "pbr-m1:buzzer";
+ gpios = <&gpio0 27 1>;
+ };
+
+ power {
+ label = "pbr-m1:green:power";
+ gpios = <&gpio0 25 1>;
+ };
+
+ sys {
+ label = "pbr-m1:green:sys";
+ gpios = <&gpio0 24 1>;
+ };
+
+ internet {
+ label = "pbr-m1:green:internet";
+ gpios = <&gpio0 23 1>;
+ };
+ };
+
+ gpio-keys-polled {
+ compatible = "gpio-keys-polled";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ poll-interval = <20>;
+ reset {
+ label = "reset";
+ gpios = <&gpio0 18 1>;
+ linux,code = <0x198>;
+ };
+ };
+
+ pinctrl {
+ state_default: pinctrl0 {
+ gpio {
+ ralink,group = "wdt", "rgmii2", "wdt rst", "jtag", "mdio";
+ ralink,function = "gpio";
+ };
+ };
+ };
+};
diff --git a/target/linux/ramips/image/Makefile b/target/linux/ramips/image/Makefile
index 106cb2d..afbe567 100644
--- a/target/linux/ramips/image/Makefile
+++ b/target/linux/ramips/image/Makefile
@@ -919,7 +919,7 @@ endif
#
ifeq ($(SUBTARGET),mt7621)
- TARGET_DEVICES += mt7621 wsr-600 wsr-1166 dir-860l-b1 firewrt
+ TARGET_DEVICES += mt7621 wsr-600 wsr-1166 dir-860l-b1 firewrt pbr-m1
endif
define Device/mt7621
@@ -956,6 +956,11 @@ define Device/firewrt
IMAGE_SIZE := $(ralink_default_fw_size_16M)
endef
+define Device/pbr-m1
+ DTS := PBR-M1
+ IMAGE_SIZE := $(ralink_default_fw_size_16M)
+endef
+
#
# MT7628 Profiles
#
diff --git a/target/linux/ramips/mt7621/profiles/pbr-m1.mk b/target/linux/ramips/mt7621/profiles/pbr-m1.mk
new file mode 100644
index 0000000..5b4dfb5
--- /dev/null
+++ b/target/linux/ramips/mt7621/profiles/pbr-m1.mk
@@ -0,0 +1,22 @@
+#
+# Copyright (C) 2011 OpenWrt.org
+#
+# This is free software, licensed under the GNU General Public License v2.
+# See /LICENSE for more information.
+#
+
+define Profile/PBR-M1
+ NAME:=PBR-M1 Device
+ PACKAGES:=\
+ kmod-usb-core kmod-usb3 kmod-usb-hid kmod-sdhci-mt7620 \
+ kmod-ledtrig-usbdev kmod-mt76 kmod-ata-core kmod-ata-ahci \
+ kmod-usb3-mt7621 kmod-rtc-pcf8563
+endef
+
+
+FEATURES+=rtc
+
+define Profile/PBR-M1/Description
+ Default package set compatible with most boards.
+endef
+$(eval $(call Profile,PBR-M1))
--
1.9.1
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.infradead.org/pipermail/openwrt-devel/attachments/20150616/dab9f520/attachment.htm>
-------------- next part --------------
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
More information about the openwrt-devel
mailing list