[OpenWrt-Devel] [PATCH] [ 2/5] ramips: change ethernet napi interrupt sequence
michael lee
igvtee at gmail.com
Tue Jun 2 09:06:42 EDT 2015
when open device. first ready napi software rx.
then enable hardware interrupt.
final start software tx queue to send data.
Signed-off-by: michael lee <igvtee at gmail.com>
---
.../ramips/files/drivers/net/ethernet/ralink/ralink_soc_eth.c | 9 ++++-----
1 file changed, 4 insertions(+), 5 deletions(-)
diff --git a/target/linux/ramips/files/drivers/net/ethernet/ralink/ralink_soc_eth.c b/target/linux/ramips/files/drivers/net/ethernet/ralink/ralink_soc_eth.c
index 60c3c91..bef715b 100644
--- a/target/linux/ramips/files/drivers/net/ethernet/ralink/ralink_soc_eth.c
+++ b/target/linux/ramips/files/drivers/net/ethernet/ralink/ralink_soc_eth.c
@@ -1153,7 +1153,6 @@ static int fe_open(struct net_device *dev)
goto err_out;
spin_lock_irqsave(&priv->page_lock, flags);
- napi_enable(&priv->rx_napi);
val = FE_TX_WB_DDONE | FE_RX_DMA_EN | FE_TX_DMA_EN;
if (priv->flags & FE_FLAG_RX_2B_OFFSET)
@@ -1169,8 +1168,9 @@ static int fe_open(struct net_device *dev)
if (priv->soc->has_carrier && priv->soc->has_carrier(priv))
netif_carrier_on(dev);
- netif_start_queue(dev);
+ napi_enable(&priv->rx_napi);
fe_int_enable(priv->soc->tx_int | priv->soc->rx_int);
+ netif_start_queue(dev);
return 0;
@@ -1185,15 +1185,14 @@ static int fe_stop(struct net_device *dev)
unsigned long flags;
int i;
- fe_int_disable(priv->soc->tx_int | priv->soc->rx_int);
-
netif_tx_disable(dev);
+ fe_int_disable(priv->soc->tx_int | priv->soc->rx_int);
+ napi_disable(&priv->rx_napi);
if (priv->phy)
priv->phy->stop(priv);
spin_lock_irqsave(&priv->page_lock, flags);
- napi_disable(&priv->rx_napi);
fe_reg_w32(fe_reg_r32(FE_REG_PDMA_GLO_CFG) &
~(FE_TX_WB_DDONE | FE_RX_DMA_EN | FE_TX_DMA_EN),
--
2.0.5
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
More information about the openwrt-devel
mailing list