[FS#4040] LinksysWRT32X - usb storage not recognized at boot

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - AP1010 (AP1010) 

Attached to Project - OpenWrt/LEDE Project
Summary - LinksysWRT32X - usb storage not recognized at boot
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Low
Priority - Very Low
Reported Version - Trunk
Due in Version - Undecided
Due Date - Undecided
Details - Booting freshly installed 21.02.0 (no customization) I get:
4.142247] usb usb2-port1: Cannot enable. Maybe the USB cable is bad?
[ 4.512230] usb 2-1: new high-speed USB device number 3 using xhci-hcd
When the system is fully up, the attached disk is not seen. If I unplug and re-plug it, the disk is recognized correctly.

When I boot 19.07.8 from the second partition of the same device (again, freshly installed, no customization), the disk is recognized at boot as expected.
[    3.610086] scsi 2:0:0:0: Direct-Access     External USB3.0           0204 PQ: 0 ANSI: 6
[    3.618679] sd 2:0:0:0: [sda] 117231408 512-byte logical blocks: (60.0 GB/55.9 GiB)
[    3.626590] sd 2:0:0:0: [sda] Write Protect is off


   

 

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=4040

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.