[PATCH 2/2] ath79: add support for Dell SonicPoint ACi APL27-0B1

[Sander Vanheule]

Hi Tomasz,

On Sun, 2025-02-02 at 16:10 +0100, Tomasz Maciej Nowak wrote:
> +	reg_usb_vbus: regulator-usb-vbus {
> +		compatible = "regulator-fixed";
> +		regulator-name = "usb-vbus";
> +		regulator-min-microvolt = <5000000>;
> +		regulator-max-microvolt = <5000000>;
> +		gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
> +	};
> +
> +	output-usb-vbus {
> +		compatible = "regulator-output";
> +		vout-supply = <&reg_usb_vbus>;
> +	};
> +};
> 
> +  DEVICE_PACKAGES += kmod-regulator-userspace-consumer

You could also add the regulator-boot-on to regulator-usb-vbus. If it is already enabled by the
bootloader, regulator-boot-on will keep it enabled. Otherwise it should cause the regulator to be
enabled (GPIO set low in this case) when the driver probes.

You could also add regulator-always-on to regulator-usb-vbus, in which case the USB port can't be
powered down anymore (from userspace). Is there any specific reason you would want to power the port
down?


Best,
Sander