[OpenWrt-Devel] [PATCH] ath79: eg200: enable status led usage

[Karl Pálsson]

This enables using the "eTactica" LED during boot, to indicate failsafe,
and during upgrade, while still leaving the LED alone for normal
operation.  This brings the device more in line with how other devices
work, and makes the failsafe functionality easier to use and understand.

Signed-off-by: Karl Palsson <karlp at etactica.com>
---
 target/linux/ath79/base-files/etc/board.d/01_leds | 1 -
 target/linux/ath79/dts/ar9331_etactica_eg200.dts  | 5 ++++-
 2 files changed, 4 insertions(+), 2 deletions(-)

diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds
index ced8a94fd0..e317ce26e1 100755
--- a/target/linux/ath79/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/base-files/etc/board.d/01_leds
@@ -87,7 +87,6 @@ engenius,ews511ap)
 etactica,eg200)
 	ucidef_set_led_netdev "lan" "LAN" "$boardname:red:eth0" "eth0"
 	ucidef_set_led_oneshot "modbus" "Modbus" "$boardname:red:modbus" "100" "33"
-	ucidef_set_led_default "etactica" "etactica" "$boardname:red:etactica" "ignore"
 	;;
 glinet,gl-ar150)
 	ucidef_set_led_netdev "wan" "WAN" "$boardname:green:wan" "eth1"
diff --git a/target/linux/ath79/dts/ar9331_etactica_eg200.dts b/target/linux/ath79/dts/ar9331_etactica_eg200.dts
index 708e9defa4..9160aa2b2e 100644
--- a/target/linux/ath79/dts/ar9331_etactica_eg200.dts
+++ b/target/linux/ath79/dts/ar9331_etactica_eg200.dts
@@ -11,6 +11,9 @@
 	compatible = "etactica,eg200", "qca,ar9331";
 
 	aliases {
+		led-boot = &led_etactica;
+		led-failsafe = &led_etactica;
+		led-upgrade = &led_etactica;
 		serial0 = &uart;
 	};
 
@@ -34,7 +37,7 @@
 			gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
 		};
 
-		etactica {
+		led_etactica: etactica {
 			label = "eg200:red:etactica";
 			gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
 		};
-- 
2.20.1


_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel