[OpenWrt-Devel] [PATCH, v5] uqmi: add explicit check for message type when expecting a response

Tautvydas Belgeras tautvydas.b at 8devices.com
Thu Jun 20 06:45:19 EDT 2019


When the utility sends a request it expects a response type message,
but does not explicitly check for it. When a device stays idle for
some time, it switches into a sleep mode, and notifies the utility with an
identification type message. In some configurations the device only sends
this identification message when triggered by the utility, in this case by
the request message. What the utility gets is two messages at the same time -
an identification and a response. When it tries to decode former it obviously
fails, because it is not what it expected.

Signed-off-by: Tautvydas Belgeras <tautvydas.b at 8devices.com>
---
 dev.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/dev.c b/dev.c
index 4bca429..bd10207 100644
--- a/dev.c
+++ b/dev.c
@@ -96,6 +96,9 @@ static void qmi_process_msg(struct qmi_dev *qmi, struct qmi_msg *msg)
 	struct qmi_request *req;
 	uint16_t tid;
 
+	if (msg->flags != QMI_CTL_FLAG_RESPONSE && msg->flags != QMI_SERVICE_FLAG_RESPONSE)
+		return;
+
 	if (msg->qmux.service == QMI_SERVICE_CTL)
 		tid = msg->ctl.transaction;
 	else
-- 
2.18.1


_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel



More information about the openwrt-devel mailing list