[OpenWrt-Devel] [PATCH v2 1/2] ath79: add Netgear WNR612 v2
Zoltan HERPAI
wigyori at uid0.hu
Wed Jun 20 10:21:07 EDT 2018
Netgear WNR612 v2:
- cpu Atheros AR7240 (Python) @400MHz
- flash 4MB
- ram 32MB
- ethernet 10/100: 1xwan + 2xlan (only two)
- radio AR9285
As there is a rebranded WNR612v2 called ON Networks N150R, add
a dtsi which includes all device support, and add a separate dts
for the device only (with a separate one for the subsequent N150R).
Signed-off-by: Zoltan HERPAI <wigyori at uid0.hu>
---
target/linux/ath79/base-files/etc/board.d/01_leds | 5 +
.../linux/ath79/base-files/etc/board.d/02_network | 6 +
.../etc/hotplug.d/firmware/10-ath9k-eeprom | 1 +
.../linux/ath79/dts/ar7240_netgear_wnr612-v2.dts | 10 ++
.../linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi | 147 +++++++++++++++++++++
target/linux/ath79/image/Makefile | 1 +
target/linux/ath79/image/tiny-netgear.mk | 19 +++
7 files changed, 189 insertions(+)
create mode 100644 target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dts
create mode 100644 target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi
create mode 100644 target/linux/ath79/image/tiny-netgear.mk
diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds
index 92b7e7d..68f94ed 100755
--- a/target/linux/ath79/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/base-files/etc/board.d/01_leds
@@ -22,6 +22,11 @@ case "$board" in
ucidef_set_led_oneshot "modbus" "Modbus" "$boardname:red:modbus" "100" "33"
ucidef_set_led_default "etactica" "etactica" "$boardname:red:etactica" "ignore"
;;
+"netgear,wnr612-v2")
+ ucidef_set_led_netdev "wan" "WAN" "netgear:green:wan" "eth0"
+ ucidef_set_led_switch "lan1" "LAN1" "netgear:green:lan1" "switch0" "0x02" "0x0f"
+ ucidef_set_led_switch "lan2" "LAN2" "netgear:green:lan2" "switch0" "0x04" "0x0f"
+ ;;
"tplink,tl-mr3020-v1")
ucidef_set_led_switch "lan" "LAN" "tp-link:green:lan" "switch0" "0x02"
;;
diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network
index f734518..2caf443 100755
--- a/target/linux/ath79/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/base-files/etc/board.d/02_network
@@ -33,6 +33,12 @@ ath79_setup_interfaces()
ucidef_set_interfaces_lan_wan "eth1" "eth0"
;;
+ "netgear,wnr612-v2")
+ ucidef_set_interfaces_lan_wan "eth1.1" "eth0"
+ ucidef_add_switch "switch0" \
+ "0 at eth1" "1:lan" "2:lan" "3:lan:3" "4:lan:4"
+ ;;
+
"tplink,tl-mr3020-v1")
ucidef_set_interface_lan "eth0.1"
ucidef_add_switch "switch0" "0 at eth0" "1:lan"
diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
index 498cc4e..1ed7460 100644
--- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
+++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
@@ -54,6 +54,7 @@ case "$FIRMWARE" in
"tplink,tl-wdr4300")
ath9k_eeprom_extract "art" 20480 1088
;;
+ "netgear,wnr612-v2"|\
"tplink,tl-wr740n-v2"|\
"ubnt,unifi")
ath9k_eeprom_extract "art" 4096 2048
diff --git a/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dts b/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dts
new file mode 100644
index 0000000..d804064
--- /dev/null
+++ b/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dts
@@ -0,0 +1,10 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "ar7240_netgear_wnr612-v2.dtsi"
+
+/ {
+ model = "Netgear WNR612 v2";
+ compatible = "netgear,wnr612-v2";
+};
+
diff --git a/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi b/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi
new file mode 100644
index 0000000..c5ceb6e
--- /dev/null
+++ b/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi
@@ -0,0 +1,147 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "ar7240.dtsi"
+
+/ {
+ compatible = "netgear,wnr612-v2", "qca,ar7240";
+ model = "Netgear WNR612 V2";
+
+ aliases {
+ led-status = &led_power;
+ };
+
+ memory at 0 {
+ device_type = "memory";
+ reg = <0x0 0x2000000>;
+ };
+
+ gpio-keys-polled {
+ compatible = "gpio-keys-polled";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ poll-interval = <20>;
+
+ reset {
+ label = "reset";
+ linux,code = <KEY_RESTART>;
+ gpios = <&ath9k 7 GPIO_ACTIVE_LOW>;
+ debounce-interval = <60>;
+ };
+ };
+
+ gpio-leds {
+ compatible = "gpio-leds";
+ led_power: power {
+ label = "netgear:green:power";
+ gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+ };
+
+ lan1 {
+ label = "netgear:green:lan1";
+ gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+ };
+
+ lan2 {
+ label = "netgear:green:lan2";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ };
+
+ wan {
+ label = "netgear:green:wan";
+ gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+ };
+
+ wlan: wlan {
+ label = "netgear:green:wlan";
+ gpios = <&ath9k 1 GPIO_ACTIVE_LOW>;
+ default-state = "off";
+ linux,default-trigger = "phy0tpt";
+ };
+ };
+};
+
+&spi {
+ status = "okay";
+ num-cs = <1>;
+
+ flash at 0 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <25000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ uboot: partition at 0 {
+ reg = <0x0 0x40000>;
+ label = "u-boot";
+ read-only;
+ };
+
+ partition at 40000 {
+ reg = <0x40000 0x10000>;
+ label = "u-boot-env";
+ };
+
+ partition at 50000 {
+ reg = <0x50000 0x3a0000>;
+ label = "firmware";
+ };
+
+ partition at 3f0000 {
+ reg = <0x3f0000 0x10000>;
+ label = "art";
+ read-only;
+ };
+ };
+ };
+};
+
+ð0 {
+ status = "okay";
+
+ phy-handle = <&phy4>;
+
+ mtd-mac-address = <&uboot 0x1fc00>;
+ mtd-mac-address-increment = <(-1)>;
+};
+
+ð1 {
+ status = "okay";
+
+ mtd-mac-address = <&uboot 0x1fc00>;
+ mtd-mac-address-increment = <1>;
+};
+
+&mdio0 {
+ status = "okay";
+
+ phy4: ethernet-phy at 4 {
+ reg = <4>;
+ phy-mode = "mii";
+ };
+};
+
+&pcie {
+ status = "okay";
+
+ ath9k: wifi at 168c,002b {
+ compatible = "pci168c,002b";
+ reg = <0x0000 0 0 0 0>;
+ qca,no-eeprom;
+ #gpio-cells = <2>;
+ gpio-controller;
+ };
+};
+
+&uart {
+ status = "okay";
+};
diff --git a/target/linux/ath79/image/Makefile b/target/linux/ath79/image/Makefile
index f4c0c1e..15f4c18 100644
--- a/target/linux/ath79/image/Makefile
+++ b/target/linux/ath79/image/Makefile
@@ -75,6 +75,7 @@ ifeq ($(SUBTARGET),nand)
include ./nand.mk
endif
ifeq ($(SUBTARGET),tiny)
+include ./tiny-netgear.mk
include ./tiny-tp-link.mk
endif
$(eval $(call BuildImage))
diff --git a/target/linux/ath79/image/tiny-netgear.mk b/target/linux/ath79/image/tiny-netgear.mk
new file mode 100644
index 0000000..81f83fd
--- /dev/null
+++ b/target/linux/ath79/image/tiny-netgear.mk
@@ -0,0 +1,19 @@
+include ./common-netgear.mk
+
+
+define Device/netgear_wnr612-v2
+ ATH_SOC := ar7240
+ DEVICE_TITLE := Netgear WNR612v2
+ DEVICE_DTS := ar7240_netgear_wnr612-v2
+ NETGEAR_KERNEL_MAGIC := 0x32303631
+ KERNEL := kernel-bin | append-dtb | lzma -d20 | netgear-uImage lzma
+ KERNEL_INITRAMFS := kernel-bin | append-dtb | lzma -d20 | netgear-uImage lzma
+ NETGEAR_BOARD_ID := REALWNR612V2
+ IMAGE_SIZE := 3904k
+ IMAGES := sysupgrade.bin factory.img
+ IMAGE/default := append-kernel | pad-to $$$$(BLOCKSIZE) | netgear-squashfs | append-rootfs | pad-rootfs
+ IMAGE/sysupgrade.bin := $$(IMAGE/default) | append-metadata | check-size $$$$(IMAGE_SIZE)
+ IMAGE/factory.img := $$(IMAGE/default) | netgear-dni | check-size $$$$(IMAGE_SIZE)
+ SUPPORTED_DEVICES := netgear,wnr612-v2 wnr612-v2
+endef
+TARGET_DEVICES += netgear_wnr612-v2
--
2.1.4
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/listinfo/openwrt-devel
More information about the openwrt-devel
mailing list