[OpenWrt-Devel] MV88E6060 switch

[Nerijus Baliunas]

On Mon, 9 Oct 2017 01:31:29 +0300 Sergey Ryazanov <ryazanov.s.a at gmail.com> wrote:

> > Just tried:
> > # ifconfig eth0 192.168.0.10 up
> > ifconfig: SIOCSIFFLAGS: Out of memory
> > # dmesg|grep eth
> > [    0.998445] eth0: MII PHY 32 on NPE-B
> > [    1.005134] eth1: MII PHY 1 on NPE-C
> > [    6.540687] eth0: link up, speed 100 Mb/s, full duplex
> > [    9.323993] eth0: link down
> > [   36.266247] device eth0 entered promiscuous mode
> 
> Check please, is there any new kernel messages after 'ifconfig ... up'
> failure (may be not directly related to eth0). Just run dmesg without
> grep.

I don't see anything suspicious. The full serial console log (dmesg included) is here -
https://paste.fedoraproject.org/paste/P5sDjdpJr1hFZ-hp~Prwcw

> It is also stranger that something bring eth0 up and then putting it
> back to down. Is these strings (eth0: link up/eth0: link down) appear
> in the kernel log during preinit procedure?

Seems so:
[    4.981198] init: - preinit -
[    6.473760] random: jshn: uninitialized urandom read (4 bytes read, 10 bits of entropy available)
[    6.544511] random: jshn: uninitialized urandom read (4 bytes read, 10 bits of entropy available)
[    6.761251] NPE-B: firmware's license can be found in /usr/share/doc/LICENSE.IPL
[    6.768796] NPE-B: firmware functionality 0x2, revision 0x2:1
[    6.776745] eth0: link up, speed 100 Mb/s, full duplex
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
[   10.310754] mount_root: jffs2 not ready yet, using temporary tmpfs overlay
[   10.359891] urandom-seed: Seed file not found (/etc/urandom.seed)
[   10.492841] eth0: link down

Regards,
Nerijus
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel