[OpenWrt-Devel] [PATCH] ar71xx: add support for qca955x sgmii/serdes calibration

[Chris Blake]

Scratch this, this is suppose to be in a patch file in
./target/linux/ar71xx/patches-4.1/, will rebase later.

On Thu, Sep 17, 2015 at 7:38 AM, Chris Blake <chrisrblake93 at gmail.com>
wrote:

> This patch is to add support for sgmii/serdes calibration from within the
> OpenWRT environment. This is needed on boards that do not use u-boot or do
> not have a pre-init process that runs calibration.
>
> Signed-off-by: Chris R Blake <chrisrblake93 at gmail.com>
>
> ---
>
> --- a/arch/mips/include/asm/mach-ath79/ar71xx_regs.h 2015-08-05
> 12:58:15.580496899 +0200
> +++ b/arch/mips/include/asm/mach-ath79/ar71xx_regs.h 2015-08-05
> 13:52:32.590857293 +0200
> @@ -360,6 +360,7 @@
>  #define QCA955X_PLL_CLK_CTRL_REG 0x08
>  #define QCA955X_PLL_ETH_XMII_CONTROL_REG 0x28
>  #define QCA955X_PLL_ETH_SGMII_CONTROL_REG 0x48
> +#define QCA955X_PLL_ETH_SGMII_SERDES_REG 0x4c
>
>  #define QCA955X_PLL_CPU_CONFIG_NFRAC_SHIFT 0
>  #define QCA955X_PLL_CPU_CONFIG_NFRAC_MASK 0x3f
> @@ -392,6 +393,10 @@
>  #define QCA955X_PLL_CLK_CTRL_DDRCLK_FROM_DDRPLL BIT(21)
>  #define QCA955X_PLL_CLK_CTRL_AHBCLK_FROM_DDRPLL BIT(24)
>
> +#define QCA955X_PLL_ETH_SGMII_SERDES_LOCK_DETECT BIT(2)
> +#define QCA955X_PLL_ETH_SGMII_SERDES_PLL_REFCLK BIT(1)
> +#define QCA955X_PLL_ETH_SGMII_SERDES_EN_PLL BIT(0)
> +
>  #define QCA956X_PLL_CPU_CONFIG_REG 0x00
>  #define QCA956X_PLL_CPU_CONFIG1_REG 0x04
>  #define QCA956X_PLL_DDR_CONFIG_REG 0x08
> @@ -1104,5 +1109,11 @@
>  #define QCA955X_ETH_CFG_RDV_DELAY BIT(16)
>  #define QCA955X_ETH_CFG_RDV_DELAY_MASK 0x3
>  #define QCA955X_ETH_CFG_RDV_DELAY_SHIFT 16
> +
> +#define QCA955X_GMAC_REG_SGMII_SERDES 0x0018
> +#define QCA955X_SGMII_SERDES_RES_CALIBRATION BIT(23)
> +#define QCA955X_SGMII_SERDES_RES_CALIBRATION_MASK 0xf
> +#define QCA955X_SGMII_SERDES_RES_CALIBRATION_SHIFT 23
> +#define QCA955X_SGMII_SERDES_LOCK_DETECT_STATUS BIT(15)
>
>  #endif /* __ASM_MACH_AR71XX_REGS_H */
> --- a/arch/mips/ath79/dev-eth.c 2015-08-05 14:17:25.757504251 +0200
> +++ b/arch/mips/ath79/dev-eth.c 2015-08-05 14:09:54.716333554 +0200
> @@ -849,6 +849,37 @@ void __init ath79_setup_qca955x_eth_rx_d
>   iounmap(base);
>  }
>
> +void __init ath79_setup_qca955x_eth_serdes_cal(unsigned int sgmii_value)
> +{
> + void __iomem *ethbase, *pllbase;
> + u32 t;
> +
> + ethbase = ioremap_nocache(QCA955X_GMAC_BASE, QCA955X_GMAC_SIZE);
> + pllbase = ioremap_nocache(AR71XX_PLL_BASE, AR71XX_PLL_SIZE);
> +
> + /* To Check the locking of the SGMII PLL */
> + t = __raw_readl(ethbase + QCA955X_GMAC_REG_SGMII_SERDES);
> + t &= ~(QCA955X_SGMII_SERDES_RES_CALIBRATION_MASK <<
> +       QCA955X_SGMII_SERDES_RES_CALIBRATION_SHIFT);
> + t |= (sgmii_value & QCA955X_SGMII_SERDES_RES_CALIBRATION_MASK) <<
> +     QCA955X_SGMII_SERDES_RES_CALIBRATION_SHIFT;
> + __raw_writel(t, ethbase + QCA955X_GMAC_REG_SGMII_SERDES);
> +
> + __raw_writel(QCA955X_PLL_ETH_SGMII_SERDES_LOCK_DETECT |
> +     QCA955X_PLL_ETH_SGMII_SERDES_PLL_REFCLK |
> +     QCA955X_PLL_ETH_SGMII_SERDES_EN_PLL,
> +     pllbase + QCA955X_PLL_ETH_SGMII_SERDES_REG);
> +
> + ath79_device_reset_clear(QCA955X_RESET_SGMII_ANALOG);
> + ath79_device_reset_clear(QCA955X_RESET_SGMII);
> +
> + while (!(__raw_readl(ethbase + QCA955X_GMAC_REG_SGMII_SERDES) &
> + QCA955X_SGMII_SERDES_LOCK_DETECT_STATUS));
> +
> + iounmap(ethbase);
> + iounmap(pllbase);
> +}
> +
>  static int ath79_eth_instance __initdata;
>  void __init ath79_register_eth(unsigned int id)
>  {
> --- a/arch/mips/ath79/dev-eth.h 2015-08-05 14:17:25.757504251 +0200
> +++ b/arch/mips/ath79/dev-eth.h 2015-08-05 13:58:20.292866210 +0200
> @@ -50,5 +50,6 @@ void ath79_setup_ar934x_eth_cfg(u32 mask
>  void ath79_setup_ar934x_eth_rx_delay(unsigned int rxd, unsigned int rxdv);
>  void ath79_setup_qca955x_eth_cfg(u32 mask);
>  void ath79_setup_qca955x_eth_rx_delay(unsigned int rxd, unsigned int
> rxdv);
> +void ath79_setup_qca955x_eth_serdes_cal(unsigned int sgmii_value);
>
>  #endif /* _ATH79_DEV_ETH_H */
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.infradead.org/pipermail/openwrt-devel/attachments/20150917/cda5d1f1/attachment.htm>
-------------- next part --------------
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel