[OpenWrt-Devel] [PATCH 2/3] authsae: Use kbit/s as mcast_rate unit like wpad

[Sven Eckelmann]

The OpenWrt wireless configuration for mcast_rate is defined as Kbit/s when
using wpa_supplicant for IBSS/802.11s and iw for unencrypted IBSS/802.11s.
But when using authsae, the unit for the same option is redefined as
Mbit/s.

Better always use the same unit for this option and don't make it backend
specific.

Signed-off-by: Sven Eckelmann <sven at open-mesh.com>
---
 package/network/services/authsae/files/lib/wifi/authsae.sh | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/package/network/services/authsae/files/lib/wifi/authsae.sh b/package/network/services/authsae/files/lib/wifi/authsae.sh
index 6582a35..ce5f32d 100644
--- a/package/network/services/authsae/files/lib/wifi/authsae.sh
+++ b/package/network/services/authsae/files/lib/wifi/authsae.sh
@@ -6,7 +6,7 @@ authsae_start_interface() {
 	local ret=1
 
 	json_get_vars mcast_rate mesh_id
-	set_default mcast_rate "12"
+	set_default mcast_rate "12000"
 
 	case "$htmode" in
 		HT20|HT40+|HT40-) mesh_htmode="$htmode";;
@@ -18,6 +18,9 @@ authsae_start_interface() {
 		*a*) mesh_band=11a;;
 	esac
 
+	# authsae only supports integer as mcast-rate and not things like 5.5
+	mcval=$(($mcast_rate / 1000))
+
 	cat > "$authsae_conf_file" <<EOF
 authsae:
 {
@@ -40,7 +43,7 @@ authsae:
     band = "$mesh_band";
     channel = $channel;
     htmode = "$mesh_htmode";
-    mcast-rate = $mcast_rate;
+    mcast-rate = $mcval;
   };
 };
 EOF
-- 
2.6.2
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel