[OpenWrt-Devel] [PATCH] lantiq: Add default LED configuration for TDW89X0.

[Mathias Kresin]

Am 16.12.2015 um 05:42 schrieb Vittorio G (VittGam):
> Signed-off-by: Vittorio Gambaletta <openwrt at vittgam.net>
>
> ---
>
> --- a/target/linux/lantiq/base-files/etc/board.d/01_leds
> +++ b/target/linux/lantiq/base-files/etc/board.d/01_leds
> @@ -38,6 +38,10 @@ BTHOMEHUBV5A)
>   	ucidef_set_led_netdev "internet" "internet" "soc:blue:broadband" "pppoa-wan"
>   	ucidef_set_led_default "dimmed" "dimmed" "dimmed" "0"
>   	;;
> +TDW8970|TDW8980)
> +	ucidef_set_led_wlan "wifi" "wifi" "ath9k-phy0" "phy0tpt"
> +	ucidef_set_led_netdev "internet" "internet" "internet" "pppoe-wan"
> +	;;
>   VGV7510KW22)
>   	ucidef_set_led_default "power" "power" "power" "1"
>   	ucidef_set_led_default "power2" "power2" "power2" "0"
> _______________________________________________
> openwrt-devel mailing list
> openwrt-devel at lists.openwrt.org
> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
>

This look unnecessary to me.
	
The default internet led configuration a few lines above, already adds 
an internet led with exactly the same values.

The same applies to the wifi led. I can not yet explain why, but the 
ath9k-phy0 led has the phy0tpt trigger configured without having the 
wifi led defined in 01_led on my TDW8980.
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel