[OpenWrt-Devel] [PATCH v5] Add support for Ubiquiti EdgeRouter X (UBNT-ERX)

Nikolay Martynov mar.kolya at gmail.com
Sat Dec 12 01:33:42 EST 2015


  Hi

>>
>> Doesn't work:
>> * No GPIO leds. All leds are controlled by switch,
>>   but stock firmware was able to control them.
>
> Try enabling SWCONFIG_LEDS and configure the trigger with
> ucidef_set_led_switch like other platforms have done.  This works for
> me with a mt7620 board.

  I've tried enabling SWCONFIG_LEDS and adding ucidef_set_led_switch
but could ntot make it work. And it also doesn't seem to produce any
log output. Is SWCONFIG_LEDS known to work with mt7621 switch? Is
there something else I need to do to enable it?
  Would this patch be acceptable without leds working? I will see if I
can make them work later.

>> Flashing procedure.
>> Stock firmware uses custom kernel patch to mount squashfs
>> from a file that is located on UBIFS volume. This makes wiping
>> out this volume from within stock firmware difficult.
>> Instead this patch builds image that is flashable by stock firmware
>> and contains initrams image (with minimal set of packages
>> to fit into kernel partition). Once this is flashed one can reboot
>> into initramfs OpenWrt and use sysupgrade to flash OpenWrt including
>> rootfs into nand.
>> Note: factory image is only built if initramfs image is enabled.
>
> Most of these info should go to a wiki page for the device.

  I was hoping to have these saved in commit message first and then
see if I can create/update wiki page for this device.

  I have other requested changes sitting it my git, so if lack of leds
support is fine I'll resubmit.

Thanks!

-- 
Martynov Nikolay.
Email: mar.kolya at gmail.com
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel



More information about the openwrt-devel mailing list