[OpenWrt-Devel] support for Sagemcom F at ST2804V7

[Eugene]

Hi again,

Thanks for rapid answer.

By default, my board id is "F at ST2804V7".
With this id, i cannot use openWrt.

My CFE bootloader allows to change it, so i changed it to "F at ST2704V2".
This change allowed openWrt to launch.

My question is "How to add openWrt support for F at ST2804V7 ? Where should
I request this ?"

BRGDS,
Eugene.

17.12.2014 00:11, José Vázquez пишет:
> Take a look at this patch:
> http://patchwork.openwrt.org/patch/6751/
> First of all you need to find your router's board id.
>
> If changing the board id CFE works then you have a some kind of solution.
>
> 2014-12-16 9:26 GMT+01:00, Eugene <jekos1 at yandex.ru>:
>> Hello,
>>
>> Is it possible to add support for Sagemcom F at ST2804V7 ?
>>
>> I tried openwrt-F at ST2704V2-squashfs-cfe.bin and some others
>> (barrier_breaker) on it,
>> bootlog (via serial port) says: Kernel panic - not syncing: unable to
>> detect bcm963xx board.
>>
>> If it is possible, i will supply all required information/data.
>>
>> P.S. Openwrt works if I change board ID in CFE to F at ST2704V2(with 'b'
>> command)
>>
>> Best regards,
>> Eugene
>> _______________________________________________
>> openwrt-devel mailing list
>> openwrt-devel at lists.openwrt.org
>> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
>>
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel