[OpenWrt-Devel] [PATCH] kirkwood: set default EA4500 switch config

[Claudio Leite]

This maps the LAN ports to eth0 and WAN port to eth1.
Since there are two interfaces the 802.1q VLAN mode
is unnecessary and left disabled. Port-based VLANs
are used instead.

Signed-off-by: Claudio Leite <leitec at staticky.com>
---
 .../kirkwood/base-files/etc/uci-defaults/02_network      | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/target/linux/kirkwood/base-files/etc/uci-defaults/02_network b/target/linux/kirkwood/base-files/etc/uci-defaults/02_network
index bc7e793..5b79687 100644
--- a/target/linux/kirkwood/base-files/etc/uci-defaults/02_network
+++ b/target/linux/kirkwood/base-files/etc/uci-defaults/02_network
@@ -20,6 +20,19 @@ set network.lan6.reqprefix='no'
 EOF
 }
 
+add_port_based_vlan() {
+	local device=$1
+	local vlan=$2
+	local ports=$3
+	uci batch <<EOF
+add network switch_vlan
+set network. at switch_vlan[-1].device='$device'
+set network. at switch_vlan[-1].vlan='$vlan'
+set network. at switch_vlan[-1].ports='$ports'
+set network. at switch_vlan[-1].port_based='1'
+EOF
+}
+
 . /lib/functions/uci-defaults.sh
 . /lib/kirkwood.sh
 
@@ -45,6 +58,9 @@ case "$board" in
 	;;
 "ea4500")
 	ucidef_set_interfaces_lan_wan "eth0" "eth1"
+	ucidef_add_switch "switch0" "1" "0"
+	add_port_based_vlan "switch0" "1" "0 1 2 3 5"
+	add_port_based_vlan "switch0" "2" "4 6"
 	;;
 *)
 	ucidef_set_interface_lan "eth0"
-- 
2.1.3
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel