[FS#3983] TX Power 2.4GHZ Stuck
openwrt-bugs at lists.openwrt.org
Sat Sep 18 08:36:58 PDT 2021
THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.
The following task has a new comment added:
FS#3983 - TX Power 2.4GHZ Stuck
User who did this - d.souza (dsouza)
I can confirm this issue also with the 5Ghz radio on a TP-Link Archer C6 3.2 (MT7621 + MT7603EN 2.4Ghz + MT7613BEN 5Ghz) running a snapshot build (r17525-a46fa5c3a7).
The issue seems to be with the M76 which is completely ignoring the "TX Power" set via LuCI and UCI. I am saying the issue seems to be the Wi-Fi driver because UCI and iwinfo everything seems to be OK.
See the example below. I've set the TX Power to 0dbm for testing purposes, and UCI and iwinfo correctly show the value I've configured:
root at ap2:~# uci show wireless.radio1
root at ap2:~# iwinfo wlan1 info
wlan1 ESSID: "dshome5ghz-tst"
Access Point: xx:xx:xx:xx:C8:40
Mode: Master Channel: 100 (5.500 GHz)
Center Channel 1: 106 2: unknown
Tx-Power: 0 dBm Link Quality: 24/70
Signal: -86 dBm Noise: -92 dBm
Bit Rate: 234.0 MBit/s
Encryption: WPA2 PSK (CCMP)
Type: nl80211 HW Mode(s): 802.11nac
Hardware: 14C3:7663 14C3:7663 [MediaTek MT7613BE]
TX power offset: none
Frequency offset: none
Supports VAPs: yes PHY name: phy1
root at ap2:~#
However the 0dBm configuration above has no effect on TX Power at all.
With TX Power configured at 0 dBm for the 5Ghz radio in the example above, Wi-Fi signal should be very weak and should work only on the same room and close to the access point.
However as seen below the signal strength measured with a laptop located about 10 meters away from the access point with a brick wall between the laptop and the access point is still strong. This is the same level as if TX Power is at 22dBm (driver default level), so in fact the TX Power configuration is not working:
ubuntu at ubuntu:~$ iwconfig wlp2s0
wlp2s0 IEEE 802.11 ESSID:"dshome5ghz-tst"
Mode:Managed Frequency:5.5 GHz Access Point: xx:xx:xx:xx:C8:40
Bit Rate=26 Mb/s Tx-Power=22 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Link Quality=42/70 Signal level=-68 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:30 Missed beacon:0
I've experimented other TX Power levels, and none configuration has any effect on OpenWRT TX Power. I am not sure if this is an OpenWRT bug or if it is in fact a MT76 driver issue to be reported upstream by OpenWRT devs.
More information can be found at the following URL:
You are receiving this message because you have requested it from the Flyspray bugtracking system. If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.
More information about the openwrt-bugs