[FS#3823] ethernet down after reboot

OpenWrt Bugs openwrt-bugs at lists.openwrt.org
Mon May 24 13:29:46 PDT 2021


A new Flyspray task has been opened.  Details are below. 

User who did this - davide (davidea2) 

Attached to Project - OpenWrt/LEDE Project
Summary - ethernet down after reboot
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Critical
Priority - Very Low
Reported Version - openwrt-21.02
Due in Version - Undecided
Due Date - Undecided
Details - the problemi is with turris omnia and owrt 21.02-rc1 , fresh installation, no additional package
the turris is connected to 
wan device
a second wan device (lan4) 
a raspberry (lan3)
a switch (lan2)

all work with the 19.07.7 
logread https://pastebin.com/XbzQL9aN
ip address https://pastebin.com/9hcES8WQ

after upgrading to 21.02.0-rc1 at first reboot , i have in the serial console an error about "partx: /dev/mmcblk0 delete/adding" , i don't know if it is normal or not

at first boot , here logread https://pastebin.com/V7Tsuvbd 
i lost the device on the lan2 , it says "LOWERLAYERDOWN" and no led light on, but the user is connected   https://pastebin.com/0033LAnL

if i reboot , here logread https://pastebin.com/8yxyvyL5 , i lost the other lan3 device , no light on https://pastebin.com/BmwRj5B3

no matter if i reboot the device or power it on/off
the front panel led litgh on according to the ip address state (UP/DOWN)

reverting to 19.07.7 , solve the problem

tried 3 time to flash 21.02 , same beahviour



More information can be found at the following URL:

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.

More information about the openwrt-bugs mailing list