[FS#3811] miniupnpd odd behaviour however enabling log_output works
openwrt-bugs at lists.openwrt.org
Fri May 14 10:51:56 PDT 2021
THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.
A new Flyspray task has been opened. Details are below.
User who did this - Francis (francisuk1989)
Attached to Project - OpenWrt/LEDE Project
Summary - miniupnpd odd behaviour however enabling log_output works
Task Type - Bug Report
Category - Packages
Status - Unconfirmed
Assigned To -
Operating System - All
Severity - High
Priority - Very Low
Reported Version - All
Due in Version - Undecided
Due Date - Undecided
Details - - Device problem occurs on
Fritzbox 7530 ipq40xx / arm_cortex-a7_neon-vfpv4
- Software versions of OpenWrt/LEDE release, packages, etc.
I have a issue with miniupnpd 2.2.1-1 i have tested both OpenWrt 19.07.7 to 21.02.0-rc1 r16046-59980f7aaf via ipq40xx.
When restarting miniupnpd it doesn't seems to work or opening any ports but gives messages like so:
Fri May 14 09:19:28 2021 daemon.notice miniupnpd: HTTP listening on port 5000
Fri May 14 09:19:28 2021 daemon.warn miniupnpd: no HTTP IPv6 address, disabling IPv6
Fri May 14 09:19:28 2021 daemon.notice miniupnpd: Listening for NAT-PMP/PCP traffic on port 5351
Now however if i enable the debug mode "option log_output '1'" and restart miniupnpd is works without issue,
No idea if it affects any other targets but for the fritzbox 7530
More information can be found at the following URL:
You are receiving this message because you have requested it from the Flyspray bugtracking system. If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.
More information about the openwrt-bugs