[FS#3597] CPE510 see 32MB of flash instead of 8MB and forget config after reboot.

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - MiNuS (bgiboudeau) 

Attached to Project - OpenWrt/LEDE Project
Summary - CPE510 see 32MB of flash instead of 8MB and forget config after reboot.
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Critical
Priority - Very Low
Reported Version - Trunk
Due in Version - Undecided
Due Date - Undecided
Details - Hello,

I'm using **imagebuilder** to generate firmware for my **TP-Link CPE510V3** and the resulting firmware is detecting the wrong amount of flash **32MB instead of 8MB**.
The result is at each reboot the device loose it's configuration.

 - Device problem occurs on: **TP-Link CPE510V3**
 - Software versions of OpenWrt/LEDE release, packages, etc.: **OpenWrt SNAPSHOT r15151-13961da6ce / LuCI Master git-20.332.74200-03c77da**
 - Steps to reproduce: Just use imagebuilder and you get this behavior.

Thx,
Brice

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3597

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.