[FS#3566] dlink 620 failsafe not reached

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - Sergey (icegood) 

Attached to Project - OpenWrt/LEDE Project
Summary - dlink 620 failsafe not reached
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Medium
Priority - Very Low
Reported Version - openwrt-19.07
Due in Version - Undecided
Due Date - Undecided
Details -  - Device problem occurs on: D-Link DIR-620 Rev A1
 - Software versions of OpenWrt/LEDE release : 	19.07.5
 


- Steps to reproduce:
 
1) enter the failsafe mode accordingly to instruction 
https://openwrt.org/docs/guide-user/troubleshooting/failsafe_and_factory_reset- 
Note that button became blinking too fast.

2) Try to connect via LAN.

Expected result: notebook's eth will obtain ip from 192.168.1.1/24

Actual result: 

-  no ip address is obtained. Router still unreachable. 
-- Led is still blinking frequently (maybe OK).


More information: unreachable mode was obtained after playing around with relayd packet and config router to repeater mode accordingly to instruction
https://openwrt.org/docs/guide-user/network/wifi/relay_configuration
 

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3566

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.