[FS#3560] bcm47xx: Latest Snapshot fails to boot on NETGEAR R6200

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - motolav (motolav) 

Attached to Project - OpenWrt/LEDE Project
Summary - bcm47xx: Latest Snapshot fails to boot on NETGEAR R6200
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Medium
Priority - Very Low
Reported Version - Trunk
Due in Version - Undecided
Due Date - Undecided
Details - After flashing the latest snapshot I noticed the device wouldn't lease out IPs
when watching the serial console I found these errors and it'd hang on starting program

The only error before was "Checksum too long"

These are the main two partitions of the device
 0x000000000000-0x000000040000 : "boot" 
 0x000000040000-0x000000f40000 : "firmware"

So I assume whatever is placed in "boot" is too large.

CFE for R6200 version: v1.0.1
Build Date: Fri May 11 13:46:43 CST 2012
Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
Found an ST compatible serial flash with 256 64KB blocks; total size 16MB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 2010.09.30.0
CPU type 0x19740: 480MHz
Tot mem: 131072 KBytes

Device eth0:  hwaddr 84-1B-5E-F5-37-41, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
**too long file.**
**LZMA boot failed**
Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)
Loading: .. 3816 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
 

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3560

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.