[FS#4206] flash can not be correctly identified & USB does not work properly
openwrt-bugs at lists.openwrt.org
Sat Dec 25 05:53:42 PST 2021
THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.
A new Flyspray task has been opened. Details are below.
User who did this - MicroDuke (MicroDuke)
Attached to Project - OpenWrt/LEDE Project
Summary - flash can not be correctly identified & USB does not work properly
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To -
Operating System - All
Severity - 高
Priority - 普通
Reported Version - openwrt-21.02
Due in Version - Undecided
Due Date - Undecided
Details - I have a mercury mw151, the CPU is ar9331, 16M/64M a port 100 megabit network port, a USB/microUSB(Power), configuration as attached.
Since there is no corresponding firmware, I have been using the firmware of ts-d084, from BB until 19.07.8 version, and used quite well.
Recently I used the latest version 21.02.1 firmware and saw that FLASH is only recognized to 8M.
Also the device does not recognize the USB drive correctly after installing the corresponding USB driver.
opkg install block-mount
opkg install kmod-usb-core
opkg install kmod-usb-storage
opkg install kmod-usb-uhci
opkg install kmod-fs-vfat
opkg install kmod-usb2
More information can be found at the following URL:
You are receiving this message because you have requested it from the Flyspray bugtracking system. If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.
More information about the openwrt-bugs