[FS#4177] 21.02.1 factory image not working on GL.Inet E750 Mudi

OpenWrt Bugs openwrt-bugs at lists.openwrt.org
Sun Dec 5 22:58:30 PST 2021


A new Flyspray task has been opened.  Details are below. 

User who did this - Tranquility76 (Tranquility76) 

Attached to Project - OpenWrt/LEDE Project
Summary - 21.02.1 factory image not working on GL.Inet E750 Mudi
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Medium
Priority - Very Low
Reported Version - openwrt-21.02
Due in Version - Undecided
Due Date - Undecided
Details - Device: GL.Inet E750 Mudi
OpenWRT: openwrt-21.02.1-ath79-nand-glinet_gl-e750-squashfs-factory.img

After flashing the device with UBOOT the reboot occurs. The display shows "Booting..." and the status bar is moving until around 90%. At this point it stops and the boot process never ends and the device is not usable any more. Turning off/on does not help.

Reverting to the original GL.Inet firmware via UBOOT makes the device working again. (Hint: The original firmware also stops at around 90% of the boot process for a minute or so but goes on after that.)


More information can be found at the following URL:

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.

More information about the openwrt-bugs mailing list