[FS#3482] WNDR3700 - config changes do not survive reboot after 'Perform Reset'

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - Rich Jarvis (_lsx) 

Attached to Project - OpenWrt/LEDE Project
Summary - WNDR3700 - config changes do not survive reboot after 'Perform Reset'
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Low
Priority - Very Low
Reported Version - openwrt-19.07
Due in Version - Undecided
Due Date - Undecided
Details - Issue occurs on WNDR3700 v1
Image used openwrt-19.07.4-ath79-generic-netgear_wndr3700-squashfs-sysupgrade.bin

Steps:

1, Flash the above sysupgrade image. 
2, Configure luci as required, all settings are saved as expected and survive any number of reboots as expected.
3, Use luci System/Backup Flash Firmware/Reset to Defaults (Perform Reset) to clear the current configuration. 
4, Post reset any changes applied to config/settings within luci no longer survive a reboot. The luci configuration returns to the default post-flash position after each reboot.

Issue is reproducible.

Workaround is to reflash and avoid using the reset functionality.

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3482

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.