[FS#3449] failsafe packet sent to udp/4919 does not match interface address

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - - (mpattera) 

Attached to Project - OpenWrt/LEDE Project
Summary - failsafe packet sent to udp/4919 does not match interface address
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Low
Priority - Very Low
Reported Version - All
Due in Version - Undecided
Due Date - Undecided
Details - Tested on Netgear EX3700 with OpenWrt 19.07.2 r10947-65030d81f3, but also applies to trunk.

During preinit the interface is configured with failsafe ip address and physical mac, so packets are sent out with sender address that may not be the same configured for the interface. This may result in conficts with other devices in the network.

It is possibile to disable those messages by setting CONFIG_TARGET_PREINIT_SHOW_NETMSG and CONFIG_TARGET_PREINIT_SUPPRESS_FAILSAFE_NETMSG, but the latter is not set in default config. It would be safer to disable messages by default.

 

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3449

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.