[PATCH] x86: add Barracuda Networks F12 interfaces

[Tomasz Maciej Nowak]

From: Tomasz Maciej Nowak <tmn505 at gmail.com>

Match interface numbers with printed numbers on device enclosure and
assign first port as WAN interface.

Notes
Serial console is available through RJ-45 port with Cisco pinout
baud: 19200, parity: none, flow control: none
The device is setup with UEFI. To enter setup hold DEL or ESC key on
boot. Default UEFI Administrator password is: bcndk1
For users using graphics IC it's advisable to disable display with:
i915.disable_display=1
appending to kernel command line inside bootloader, to save about
0.5-0.6W energy on idle.
For users not using graphics IC, disable it in UEFI, this will save about
1.5W energy on idle.
Pins marked CN19 are ATX power On/Off button.

Signed-off-by: Tomasz Maciej Nowak <tmn505 at gmail.com>
---
 target/linux/x86/base-files/etc/board.d/02_network | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/target/linux/x86/base-files/etc/board.d/02_network b/target/linux/x86/base-files/etc/board.d/02_network
index 5befba0a62d0..094a45f91483 100644
--- a/target/linux/x86/base-files/etc/board.d/02_network
+++ b/target/linux/x86/base-files/etc/board.d/02_network
@@ -8,6 +8,14 @@
 board_config_update
 
 case "$(board_name)" in
+barracuda-networks-inc-barracuda-ng-firewall-f12)
+	ucidef_set_network_device_path "eth1" "pci0000:00/0000:00:14.0/0000:01:00.0"
+	ucidef_set_network_device_path "eth2" "pci0000:00/0000:00:14.1/0000:02:00.0"
+	ucidef_set_network_device_path "eth3" "pci0000:00/0000:00:13.0/0000:03:00.0"
+	ucidef_set_network_device_path "eth4" "pci0000:00/0000:00:13.1/0000:04:00.0"
+	ucidef_set_network_device_path "eth5" "pci0000:00/0000:00:13.2/0000:05:00.0"
+	ucidef_set_interfaces_lan_wan "eth2 eth3 eth4 eth5" "eth1"
+	;;
 cisco-mx100-hw)
 	ucidef_set_network_device_path "mgmt" "pci0000:00/0000:00:01.2/0000:03:00.3"
 	ucidef_set_network_device_path "wan" "pci0000:00/0000:00:01.2/0000:03:00.2"
-- 
2.39.1