[PATCH 0/6] backport fixes and improvements for MT7530

[DENG Qingfang]

On Sun, Feb 6, 2022 at 2:43 AM Hauke Mehrtens <hauke at hauke-m.de> wrote:
>
> Hi,
>
> When I remove this check it works for me:

If you change the check to PHY_INTERFACE_MODE_NA, does it still work?

> -------------------
> [    1.257277] mtk_hsdma 1b007000.dma-controller: MediaTek HSDMA driver
> registered
> [    1.300344] mt7530 mdio-bus:00: no interrupt support
> [    1.321463] mt7530 mdio-bus:00 lan1 (uninitialized): PHY
> [mt7530-0:00] driver [MediaTek MT7531 PHY] (irq=POLL)
> [    1.341285] mt7530 mdio-bus:00 lan2 (uninitialized): PHY
> [mt7530-0:01] driver [MediaTek MT7531 PHY] (irq=POLL)
> [    1.361106] mt7530 mdio-bus:00 lan3 (uninitialized): PHY
> [mt7530-0:02] driver [MediaTek MT7531 PHY] (irq=POLL)
> [    1.380935] mt7530 mdio-bus:00 lan4 (uninitialized): PHY
> [mt7530-0:03] driver [MediaTek MT7531 PHY] (irq=POLL)
> [    1.400947] mt7530 mdio-bus:00 wan (uninitialized): PHY [mt7530-0:04]
> driver [MediaTek MT7531 PHY] (irq=POLL)
> [    1.412626] mt7530 mdio-bus:00: configuring for fixed/2500base-x link
> mode
> [    1.419713] DSA: tree 0 setup
> [    1.419879] mt7530 mdio-bus:00: Link is Up - 2.5Gbps/Full - flow
> control rx/tx
> ------------------------
>
> I already pushed the revert for these two patches already.
> Could you send a new patches and test them also on other platforms please.
>
> Hauke