[PATCH v2] realtek: do not reset SerDes on link change

[Birger Koblitz]

Do not reset the RTL930x SerDes on link changes, instead set up
the SDS with internal PHYs for the SFP+ ports only.
This fixes the 8 1GBit ports on the Zyxel XGS1250 which
do not work without this patch.

Tested-by: Stijn Segers <foss at volatilesystems.org>
Signed-off-by: Birger Koblitz <git at birger-koblitz.de>
---
v2: A different patch was previously sent with this subject.
    This is the correct patch.
 target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/dsa.c  | 3 ++-
 .../linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/rtl83xx.h | 1 +
 2 files changed, 3 insertions(+), 1 deletion(-)

diff --git a/target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/dsa.c b/target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/dsa.c
index 858b692640..5f19a1f590 100644
--- a/target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/dsa.c
+++ b/target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/dsa.c
@@ -814,7 +814,8 @@ static void rtl93xx_phylink_mac_config(struct dsa_switch *ds, int port,
 			       __func__, phy_modes(state->interface));
 			return;
 		}
-		rtl9300_sds_rst(sds_num, sds_mode);
+		if (state->interface == PHY_INTERFACE_MODE_10GBASER)
+			rtl9300_serdes_setup(sds_num, state->interface);
 	}

 	reg = sw_r32(priv->r->mac_force_mode_ctrl(port));
diff --git a/target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/rtl83xx.h b/target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/rtl83xx.h
index 0bb11f9b8b..107016469c 100644
--- a/target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/rtl83xx.h
+++ b/target/linux/realtek/files-5.10/drivers/net/dsa/rtl83xx/rtl83xx.h
@@ -121,6 +121,7 @@ irqreturn_t rtl839x_switch_irq(int irq, void *dev_id);
 void rtl930x_vlan_profile_dump(int index);
 int rtl9300_sds_power(int mac, int val);
 void rtl9300_sds_rst(int sds_num, u32 mode);
+int rtl9300_serdes_setup(int sds_num, phy_interface_t phy_mode);
 void rtl930x_print_matrix(void);

 /* RTL931x-specific */
-- 
2.25.1