[PATCH 2/2] x86: add Roqos Core RC10 ethernet interfaces

[Tomasz Maciej Nowak]

eth0 -> single NIC (i211at)
eth1 -> single NIC (i211at) -> 4-port unmanaged switch (BCM53125U)

Notes
UART is exposed on J4 connector, pinout starting from pin marked 1:
1. GND, 2. NC?, 3. NC?, 4. RX, 5. TX, 6. NC?
baud: 115200, parity: none, flow control: none
The board is setup by coreboot with UEFI. To enter setup screen hold
ESC key on boot.
The 5-LED multicolor matrix is attached on first I2C device named
"Synopsys DesignWare I2C adapter" at address 0x60. Controlling values
are stored in /opt/roqos/etc/rcLED.conf of original firmware.
Remember to backup the original firmware, there are no downloadable
copies.

Signed-off-by: Tomasz Maciej Nowak <tmn505 at gmail.com>
---
 target/linux/x86/base-files/etc/board.d/02_network | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/target/linux/x86/base-files/etc/board.d/02_network b/target/linux/x86/base-files/etc/board.d/02_network
index 581daf49b6e2..30035dcbe98c 100644
--- a/target/linux/x86/base-files/etc/board.d/02_network
+++ b/target/linux/x86/base-files/etc/board.d/02_network
@@ -11,6 +11,9 @@ case "$(board_name)" in
 pc-engines-apu1|pc-engines-apu2|pc-engines-apu3)
 	ucidef_set_interfaces_lan_wan "eth1 eth2" "eth0"
 	;;
+roqos-roqos-core-rc10)
+	ucidef_set_interfaces_lan_wan "eth1" "eth0"
+	;;
 sophos-sg-105|sophos-xg-105)
 	ucidef_set_interfaces_lan_wan "eth0 eth2 eth3" "eth1"
 	;;
-- 
2.31.1