[PATCH v2 11/14] realtek: switch target to upstream platform
Sander Vanheule
sander at svanheule.net
Sun Dec 12 12:01:33 PST 2021
Use the upstream MACH_REALTEK_RTL platform instead of the downstream
RTL83XX platform. This effectively deprecates the original platform.
The updated config was generated by kernel_oldconfig, using the defaults
for the now available symbols.
Since the upstream platform is based on MIPS_GENERIC, the kernel load
and entry addresses need to be updated to match the expected values.
Co-developed-by: INAGAKI Hiroshi <musashino.open at gmail.com>
Signed-off-by: INAGAKI Hiroshi <musashino.open at gmail.com>
Signed-off-by: Sander Vanheule <sander at svanheule.net>
Tested-by: Bjørn Mork <bjorn at mork.no>
---
target/linux/realtek/config-5.10 | 36 ++++++++++++++++++++++++-----
target/linux/realtek/image/Makefile | 4 ++--
2 files changed, 32 insertions(+), 8 deletions(-)
diff --git a/target/linux/realtek/config-5.10 b/target/linux/realtek/config-5.10
index f75cf92897ad..eb3eb0e2b51c 100644
--- a/target/linux/realtek/config-5.10
+++ b/target/linux/realtek/config-5.10
@@ -1,9 +1,7 @@
CONFIG_AQUANTIA_PHY=y
CONFIG_ARCH_32BIT_OFF_T=y
-CONFIG_ARCH_HIBERNATION_POSSIBLE=y
CONFIG_ARCH_MMAP_RND_BITS_MAX=15
CONFIG_ARCH_MMAP_RND_COMPAT_BITS_MAX=15
-CONFIG_ARCH_SUSPEND_POSSIBLE=y
CONFIG_BLK_DEV_RAM=y
CONFIG_BLK_DEV_RAM_COUNT=16
CONFIG_BLK_DEV_RAM_SIZE=4096
@@ -25,8 +23,11 @@ CONFIG_CPU_MIPS32=y
# CONFIG_CPU_MIPS32_R1 is not set
CONFIG_CPU_MIPS32_R2=y
CONFIG_CPU_MIPSR2=y
+CONFIG_CPU_MIPSR2_IRQ_EI=y
+CONFIG_CPU_MIPSR2_IRQ_VI=y
CONFIG_CPU_NEEDS_NO_SMARTMIPS_OR_MICROMIPS=y
CONFIG_CPU_R4K_CACHE_TLB=y
+CONFIG_CPU_RMAP=y
CONFIG_CPU_SUPPORTS_32BIT_KERNEL=y
CONFIG_CPU_SUPPORTS_HIGHMEM=y
CONFIG_CPU_SUPPORTS_MSA=y
@@ -89,6 +90,7 @@ CONFIG_I2C_GPIO=y
CONFIG_INITRAMFS_SOURCE=""
CONFIG_IRQCHIP=y
CONFIG_IRQ_DOMAIN=y
+CONFIG_IRQ_DOMAIN_HIERARCHY=y
CONFIG_IRQ_FORCED_THREADING=y
CONFIG_IRQ_MIPS_CPU=y
CONFIG_IRQ_WORK=y
@@ -99,6 +101,7 @@ CONFIG_LEGACY_PTY_COUNT=256
CONFIG_LIBFDT=y
CONFIG_LLD_VERSION=0
CONFIG_LOCK_DEBUGGING_SUPPORT=y
+CONFIG_MACH_REALTEK_RTL=y
CONFIG_MARVELL_PHY=y
CONFIG_MDIO_BUS=y
CONFIG_MDIO_DEVICE=y
@@ -110,17 +113,24 @@ CONFIG_MIGRATION=y
CONFIG_MIPS=y
CONFIG_MIPS_ASID_BITS=8
CONFIG_MIPS_ASID_SHIFT=0
-CONFIG_MIPS_CBPF_JIT=y
CONFIG_MIPS_CLOCK_VSYSCALL=y
# CONFIG_MIPS_CMDLINE_DTB_EXTEND is not set
# CONFIG_MIPS_CMDLINE_FROM_BOOTLOADER is not set
CONFIG_MIPS_CMDLINE_FROM_DTB=y
+CONFIG_MIPS_EBPF_JIT=y
# CONFIG_MIPS_ELF_APPENDED_DTB is not set
+CONFIG_MIPS_GENERIC=y
CONFIG_MIPS_L1_CACHE_SHIFT=5
CONFIG_MIPS_LD_CAN_LINK_VDSO=y
+CONFIG_MIPS_MT=y
+CONFIG_MIPS_MT_FPAFF=y
+CONFIG_MIPS_MT_SMP=y
# CONFIG_MIPS_NO_APPENDED_DTB is not set
+CONFIG_MIPS_NR_CPU_NR_MAP=2
+CONFIG_MIPS_PERF_SHARED_TC_COUNTERS=y
CONFIG_MIPS_RAW_APPENDED_DTB=y
CONFIG_MIPS_SPRAM=y
+# CONFIG_MIPS_VPE_LOADER is not set
CONFIG_MODULES_USE_ELF_REL=y
CONFIG_MTD_CFI_ADV_OPTIONS=y
CONFIG_MTD_CFI_GEOMETRY=y
@@ -133,14 +143,15 @@ CONFIG_MTD_SPLIT_FIRMWARE=y
CONFIG_MTD_SPLIT_TPLINK_FW=y
CONFIG_MTD_SPLIT_UIMAGE_FW=y
CONFIG_NEED_DMA_MAP_STATE=y
-CONFIG_NEED_PER_CPU_KM=y
CONFIG_NET_DEVLINK=y
CONFIG_NET_DSA=y
CONFIG_NET_DSA_RTL83XX=y
CONFIG_NET_DSA_TAG_TRAILER=y
+CONFIG_NET_FLOW_LIMIT=y
CONFIG_NET_RTL838X=y
CONFIG_NET_SWITCHDEV=y
CONFIG_NO_GENERIC_PCI_IOPORT_MAP=y
+CONFIG_NR_CPUS=2
CONFIG_NVMEM=y
CONFIG_OF=y
CONFIG_OF_ADDRESS=y
@@ -151,6 +162,7 @@ CONFIG_OF_IRQ=y
CONFIG_OF_KOBJ=y
CONFIG_OF_MDIO=y
CONFIG_OF_NET=y
+CONFIG_PADATA=y
CONFIG_PCI_DRIVERS_LEGACY=y
CONFIG_PERF_USE_VMALLOC=y
CONFIG_PGTABLE_LEVELS=2
@@ -160,6 +172,8 @@ CONFIG_PINCTRL=y
CONFIG_POWER_RESET=y
CONFIG_POWER_RESET_GPIO_RESTART=y
CONFIG_POWER_RESET_SYSCON=y
+CONFIG_QUEUED_RWLOCKS=y
+CONFIG_QUEUED_SPINLOCKS=y
CONFIG_RATIONAL=y
CONFIG_REALTEK_OTTO_WDT=y
CONFIG_REALTEK_PHY=y
@@ -167,16 +181,20 @@ CONFIG_REALTEK_SOC_PHY=y
CONFIG_REGMAP=y
CONFIG_REGMAP_MMIO=y
CONFIG_RESET_CONTROLLER=y
-CONFIG_RTL838X=y
+CONFIG_RFS_ACCEL=y
+CONFIG_RPS=y
CONFIG_RTL9300_TIMER=y
CONFIG_SERIAL_MCTRL_GPIO=y
CONFIG_SERIAL_OF_PLATFORM=y
CONFIG_SFP=y
+CONFIG_SMP=y
+CONFIG_SMP_UP=y
CONFIG_SPI=y
CONFIG_SPI_MASTER=y
CONFIG_SPI_MEM=y
CONFIG_SRCU=y
CONFIG_SWPHY=y
+CONFIG_SYNC_R4K=y
CONFIG_SYSCTL_EXCEPTION_TRACE=y
CONFIG_SYS_HAS_CPU_MIPS32_R1=y
CONFIG_SYS_HAS_CPU_MIPS32_R2=y
@@ -185,13 +203,19 @@ CONFIG_SYS_SUPPORTS_32BIT_KERNEL=y
CONFIG_SYS_SUPPORTS_ARBIT_HZ=y
CONFIG_SYS_SUPPORTS_BIG_ENDIAN=y
CONFIG_SYS_SUPPORTS_MIPS16=y
+CONFIG_SYS_SUPPORTS_MULTITHREADING=y
+CONFIG_SYS_SUPPORTS_SCHED_SMT=y
+CONFIG_SYS_SUPPORTS_SMP=y
+CONFIG_SYS_SUPPORTS_VPE_LOADER=y
CONFIG_TARGET_ISA_REV=2
CONFIG_TICK_CPU_ACCOUNTING=y
CONFIG_TIMER_OF=y
CONFIG_TIMER_PROBE=y
-CONFIG_TINY_SRCU=y
+CONFIG_TREE_RCU=y
+CONFIG_TREE_SRCU=y
CONFIG_USE_GENERIC_EARLY_PRINTK_8250=y
CONFIG_USE_OF=y
CONFIG_WATCHDOG_CORE=y
+CONFIG_XPS=y
CONFIG_ZLIB_DEFLATE=y
CONFIG_ZLIB_INFLATE=y
diff --git a/target/linux/realtek/image/Makefile b/target/linux/realtek/image/Makefile
index a7961970a302..84cfc5a9c679 100644
--- a/target/linux/realtek/image/Makefile
+++ b/target/linux/realtek/image/Makefile
@@ -3,8 +3,8 @@
include $(TOPDIR)/rules.mk
include $(INCLUDE_DIR)/image.mk
-KERNEL_LOADADDR = 0x80000000
-KERNEL_ENTRY = 0x80000400
+KERNEL_LOADADDR = 0x80100000
+KERNEL_ENTRY = 0x80100400
DEVICE_VARS += ZYXEL_VERS
--
2.33.1
More information about the openwrt-devel
mailing list