[OpenWrt-Devel] [LEDE-DEV] Ubnt power beam board - back to defaults after reboot
jiri at resnulli.us
Thu Oct 20 04:20:51 EDT 2016
Thu, Oct 20, 2016 at 09:48:48AM CEST, gareth41 at orcon.net.nz wrote:
>This is a common problem on XM devices due to new uboot on AirOS >= 5.6.x,
>although I haven't got any XW devices to test but its possibly the same?
>Try downgrading back to AirOS v5.5.11 or less or apply the following patches
>which I can confirm fix the problem on my XM devices.
Ok, will try, thanks. But why these patches are not merged to openwrt master?
Also, it be would be nice to mention this on the wiki.
>From: Lede-dev [mailto:lede-dev-bounces at lists.infradead.org] On Behalf Of
>Sent: Thursday, 20 October 2016 8:29 p.m.
>To: openwrt-devel at lists.openwrt.org; lede-dev at lists.infradead.org
>Subject: [LEDE-DEV] Ubnt power beam board - back to defaults after reboot
>Trying Ubiquity power beam M5. According to the instructions on openwrt
>wiki, I'm using loco m5 firmware. All looks fine, only configuration is lost
>after every reboot.
>All with the same result.
>I remember I had some similar problem in past on a different board, and I
>believe that there was and issue on definition of nand size. Not really
>Lede-dev mailing list
>Lede-dev at lists.infradead.org
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
More information about the openwrt-devel