[OpenWrt-Devel] BT Home Hub 5 support

[Mauro M.]

Hello,

 From the OpenWrt wiki page: https://wiki.openwrt.org/toh/bt/homehub_v5a
I understand that support for BT Home Hub 5 was included in DD trunk.

I pulled the latest trunk source 50013 from git, but the image is not 
built under bin/lantiq as expected.

As deducted from the firmware images available on-line 
(openwrt-lantiq-xrx200-BTHOMEHUBV5A-install-uImage-initramfs 
<https://dl.dropboxusercontent.com/u/26940713/OpenWrt/openwrt-lantiq-xrx200-BTHOMEHUBV5A-install-uImage-initramfs>) 
I am using:
Target System (Lantiq)  --->
Subtarget (XRX200)  --->
Target Profile (Default Profile)  --->

There is nothing else other than Default Profile. I was expecting to 
find a specific BTHOMEHUB5 configuration.

I run a grep on the code and I found  the following:

./target/linux/lantiq/image/Makefile:Image/BuildKernel/Profile/BTHOMEHUBV5A=$(call 
Image/BuildKernel/Template,BTHOMEHUBV5A)
./target/linux/lantiq/image/Makefile:Image/Build/Profile/BTHOMEHUBV5A=$(call 
Image/BuildNAND/$(1),$(1),BTHOMEHUBV5A)
./target/linux/lantiq/image/Makefile:define LegacyDevice/BTHOMEHUBV5A
./target/linux/lantiq/image/Makefile:LEGACY_DEVICES += BTHOMEHUBV5A
./target/linux/lantiq/base-files/etc/board.d/01_leds:BTHOMEHUBV5A)
./target/linux/lantiq/base-files/etc/board.d/02_network:BTHOMEHUBV5A)
./target/linux/lantiq/base-files/etc/hotplug.d/firmware/11-ath10k-caldata: 
     BTHOMEHUBV5A)
./target/linux/lantiq/dts/BTHOMEHUBV5A.dts:    model = "BTHOMEHUBV5A - 
BT Home Hub 5A";

However I am not sure how to activate the build.
Please could you help?

Thank you in advance,
Mauro
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.infradead.org/pipermail/openwrt-devel/attachments/20161129/c2f41cfc/attachment.htm>
-------------- next part --------------
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel