[OpenWrt-Devel] [PATCH v5 2/5] ar71xx: add support for qca955x sgmii/serdes calibration

John Crispin blogic at openwrt.org
Sat Nov 21 14:46:03 EST 2015


Hi,

same as on 1/5 the registers are not set in the right part of the code

	John

On 22/09/2015 18:49, Chris R Blake wrote:
> From: Chris R Blake <chrisrblake93 at gmail.com>
> 
> This patch is to add support for sgmii/serdes calibration from
> within the OpenWRT environment. This is needed on boards that
> do not use u-boot or do not have a pre-init process that runs
> calibration.
> 
> Signed-off-by: Chris R Blake <chrisrblake93 at gmail.com>
> ---
>  ...S-ath79-add-qca955x-mac-sgmii-calibration.patch | 82 ++++++++++++++++++++++
>  1 file changed, 82 insertions(+)
>  create mode 100644 target/linux/ar71xx/patches-4.1/743-MIPS-ath79-add-qca955x-mac-sgmii-calibration.patch
> 
> diff --git a/target/linux/ar71xx/patches-4.1/743-MIPS-ath79-add-qca955x-mac-sgmii-calibration.patch b/target/linux/ar71xx/patches-4.1/743-MIPS-ath79-add-qca955x-mac-sgmii-calibration.patch
> new file mode 100644
> index 0000000..eb7c5de
> --- /dev/null
> +++ b/target/linux/ar71xx/patches-4.1/743-MIPS-ath79-add-qca955x-mac-sgmii-calibration.patch
> @@ -0,0 +1,82 @@
> +--- a/arch/mips/include/asm/mach-ath79/ar71xx_regs.h	2015-08-05 12:58:15.580496899 +0200
> ++++ b/arch/mips/include/asm/mach-ath79/ar71xx_regs.h	2015-08-05 13:52:32.590857293 +0200
> +@@ -360,6 +360,7 @@
> + #define QCA955X_PLL_CLK_CTRL_REG		0x08
> + #define QCA955X_PLL_ETH_XMII_CONTROL_REG	0x28
> + #define QCA955X_PLL_ETH_SGMII_CONTROL_REG	0x48
> ++#define QCA955X_PLL_ETH_SGMII_SERDES_REG	0x4c
> +
> + #define QCA955X_PLL_CPU_CONFIG_NFRAC_SHIFT	0
> + #define QCA955X_PLL_CPU_CONFIG_NFRAC_MASK	0x3f
> +@@ -392,6 +393,10 @@
> + #define QCA955X_PLL_CLK_CTRL_DDRCLK_FROM_DDRPLL		BIT(21)
> + #define QCA955X_PLL_CLK_CTRL_AHBCLK_FROM_DDRPLL		BIT(24)
> +
> ++#define QCA955X_PLL_ETH_SGMII_SERDES_LOCK_DETECT	BIT(2)
> ++#define QCA955X_PLL_ETH_SGMII_SERDES_PLL_REFCLK		BIT(1)
> ++#define QCA955X_PLL_ETH_SGMII_SERDES_EN_PLL		BIT(0)
> ++
> + #define QCA956X_PLL_CPU_CONFIG_REG			0x00
> + #define QCA956X_PLL_CPU_CONFIG1_REG			0x04
> + #define QCA956X_PLL_DDR_CONFIG_REG			0x08
> +@@ -1104,5 +1109,11 @@
> + #define QCA955X_ETH_CFG_RDV_DELAY	BIT(16)
> + #define QCA955X_ETH_CFG_RDV_DELAY_MASK	0x3
> + #define QCA955X_ETH_CFG_RDV_DELAY_SHIFT	16
> ++
> ++#define QCA955X_GMAC_REG_SGMII_SERDES			0x0018
> ++#define QCA955X_SGMII_SERDES_RES_CALIBRATION		BIT(23)
> ++#define QCA955X_SGMII_SERDES_RES_CALIBRATION_MASK	0xf
> ++#define QCA955X_SGMII_SERDES_RES_CALIBRATION_SHIFT	23
> ++#define QCA955X_SGMII_SERDES_LOCK_DETECT_STATUS		BIT(15)
> +
> + #endif /* __ASM_MACH_AR71XX_REGS_H */
> +--- a/arch/mips/ath79/dev-eth.c	2015-08-05 14:17:25.757504251 +0200
> ++++ b/arch/mips/ath79/dev-eth.c	2015-08-05 14:09:54.716333554 +0200
> +@@ -849,6 +849,37 @@ void __init ath79_setup_qca955x_eth_rx_d
> + 	iounmap(base);
> + }
> +
> ++void __init ath79_setup_qca955x_eth_serdes_cal(unsigned int sgmii_value)
> ++{
> ++	void __iomem *ethbase, *pllbase;
> ++	u32 t;
> ++
> ++	ethbase = ioremap_nocache(QCA955X_GMAC_BASE, QCA955X_GMAC_SIZE);
> ++	pllbase = ioremap_nocache(AR71XX_PLL_BASE, AR71XX_PLL_SIZE);
> ++
> ++	/* To Check the locking of the SGMII PLL */
> ++	t = __raw_readl(ethbase + QCA955X_GMAC_REG_SGMII_SERDES);
> ++	t &= ~(QCA955X_SGMII_SERDES_RES_CALIBRATION_MASK <<
> ++	       QCA955X_SGMII_SERDES_RES_CALIBRATION_SHIFT);
> ++	t |= (sgmii_value & QCA955X_SGMII_SERDES_RES_CALIBRATION_MASK) <<
> ++	     QCA955X_SGMII_SERDES_RES_CALIBRATION_SHIFT;
> ++	__raw_writel(t, ethbase + QCA955X_GMAC_REG_SGMII_SERDES);
> ++
> ++	__raw_writel(QCA955X_PLL_ETH_SGMII_SERDES_LOCK_DETECT |
> ++		     QCA955X_PLL_ETH_SGMII_SERDES_PLL_REFCLK |
> ++		     QCA955X_PLL_ETH_SGMII_SERDES_EN_PLL,
> ++		     pllbase + QCA955X_PLL_ETH_SGMII_SERDES_REG);
> ++
> ++	ath79_device_reset_clear(QCA955X_RESET_SGMII_ANALOG);
> ++	ath79_device_reset_clear(QCA955X_RESET_SGMII);
> ++
> ++	while (!(__raw_readl(ethbase + QCA955X_GMAC_REG_SGMII_SERDES) &
> ++		QCA955X_SGMII_SERDES_LOCK_DETECT_STATUS));
> ++
> ++	iounmap(ethbase);
> ++	iounmap(pllbase);
> ++}
> ++
> + static int ath79_eth_instance __initdata;
> + void __init ath79_register_eth(unsigned int id)
> + {
> +--- a/arch/mips/ath79/dev-eth.h	2015-08-05 14:17:25.757504251 +0200
> ++++ b/arch/mips/ath79/dev-eth.h	2015-08-05 13:58:20.292866210 +0200
> +@@ -50,5 +50,6 @@ void ath79_setup_ar934x_eth_cfg(u32 mask
> + void ath79_setup_ar934x_eth_rx_delay(unsigned int rxd, unsigned int rxdv);
> + void ath79_setup_qca955x_eth_cfg(u32 mask);
> + void ath79_setup_qca955x_eth_rx_delay(unsigned int rxd, unsigned int rxdv);
> ++void ath79_setup_qca955x_eth_serdes_cal(unsigned int sgmii_value);
> +
> + #endif /* _ATH79_DEV_ETH_H */
> 
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel



More information about the openwrt-devel mailing list