[OpenWrt-Devel] [PATCH] ar71xx: add support for the UniFi AP Outdoor Plus

Kirill Berezin kyb22 at rol.ru
Tue May 19 09:15:34 EDT 2015



Hello,

I succeed to recover a disable command (I followed tips from the 
Stefan's post).
A simple user space configuration utility is in the attachment. Compile 
it then run the following before a setup of an interface

./hsr 98

What'll be available : scan shows channels 1 and 11; clients on channels 
1 and 11 can connect and transmit data; n mode works.

I think that they tune an external receiver via some sort of SPI bus 
(GPIO pins are 5,6,7,8). Write procedure is quite simple, but I can't 
still get how enable works (for sure it sends a disable); it is quite 
possible that we need to read from a device before sending a command.


Kirill.

P.S. Sorry for duplicate from the different address.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: hsr.c
Type: text/x-csrc
Size: 5829 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/openwrt-devel/attachments/20150519/fa7a36e2/attachment.bin>
-------------- next part --------------
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel


More information about the openwrt-devel mailing list