[OpenWrt-Devel] Change Uboot default values
bapclenet at gmail.com
Wed Jul 22 08:18:40 EDT 2015
2015-07-22 13:54 GMT+02:00 Yousong Zhou <yszhou4tech at gmail.com>:
> On 22 July 2015 at 19:37, Baptiste Clenet <bapclenet at gmail.com> wrote:
>> I would like to change the default values of Uboot when I choose 2 in the menu.
>> In the below example, I would like to change <1>, <2> and <3> by
>> defaults values that I would have set earlier.
> Looks like it's most likely hardcoded .
>  https://github.com/8devices/u-boot/blob/a4ac3be49389f0801cae4c37454e59679d56f036/lib_mips/board.c#L1502
Yeah, but how to change the value then, I don't mind to hardcode them,
it's to flash quicker (not enter each time the values).
I changed it on one board but I don't remember how I have done that.
>> Please choose the operation:
>> 1: Load system code to SDRAM via TFTP.
>> 2: Load system code then write to Flash via TFTP.
>> 3: Boot system code via Flash (default).
>> 4: Entr boot command line interface.
>> 7: Load Boot Loader code then write to Flash via Serial.
>> 9: Load Boot Loader code then write to Flash via TFTP.
>> You choosed 2
>> 2: System Load Linux Kernel then write to Flash via TFTP.
>> Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N)
>> Please Input new ones /or Ctrl-C to discard
>> Input device IP (10.10.10.123) ==: <1>
>> Input server IP (10.10.10.3) ==: <2>
>> Input Linux Kernel filename () ==:<3>
>> openwrt-devel mailing list
>> openwrt-devel at lists.openwrt.org
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
More information about the openwrt-devel