[OpenWrt-Devel] swconfig: set pvid to the same value as vid for untagged ports?
leroi.lists at gmail.com
Thu Apr 2 21:11:20 EDT 2015
On 31 March 2015 at 00:10, Roman Yeryomin <leroi.lists at gmail.com> wrote:
> I was little bit surprised it's not so currently.
> Although I understand that, potentially, there are use cases when you
> want port pvid to be different from it's untagged vlan id, but usually
> one wants port ingress traffic to fall into the same vlan as it's
> untagged egress traffic. Even more, current luci interface ignores
> 'switch_port' section of /etc/config/network making it impossible to
> change pvid from web ui.
> Also if one creates a new vlan most likely he will need a new
> interface (e.g. eth0.10 for vlan 10). This is not obvious for a
> "regular" user.
> I think it would be much better if netifd (or whoever does it) would
> at least set pvid to vid value for untagged ports in same vlan group.
> I can try doing it myself if somebody can give me the pointers to
> where the changes should go.
> Did I overlook something? Are there other/better options?
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
More information about the openwrt-devel