[OpenWrt-Devel] [PATCH] lantiq xway: generate ramdisk image by default

[Ben Mulvihill]

No problem. I'll try to make sure there is a link to a
non-official ramdisk image on the wiki. (Along with some
installation instructions, which at the moment are lacking!)

Ben

On Sun, 2014-07-20 at 08:54 +0200, John Crispin wrote:
> technically correct. however there is a dependency bug left over from
> some cargo cult cleanups. this causes the image builder to not build
> when ramdisk is enabled. i plan to clean this up post BB. i will
> ignore this patch until said time.
> 
> 	John
> 
> On 19/07/2014 15:13, Ben Mulvihill wrote:
> > The installation process on nand-based boards using ubi like the 
> > BTHOMEHUBV2B makes use of a ramdisk image, so it makes sense to 
> > generate this by default.
> > 
> > Signed-off-by: Ben Mulvihill <ben.mulvihill at gmail.com> --- --- 
> > a/target/linux/lantiq/xway/target.mk	2014-07-19 14:59:39.691201637 
> > +0200 +++ b/target/linux/lantiq/xway/target.mk	2014-07-19 
> > 12:40:06.101871732 +0200 @@ -1,7 +1,7 @@ ARCH:=mips SUBTARGET:=xway
> > BOARDNAME:=XWAY -FEATURES:=squashfs atm mips16 nand ubifs
> > +FEATURES:=squashfs atm mips16 nand ubifs ramdisk CPU_TYPE:=34kc
> > CPU_SUBTYPE:=dsp
> > 
> > _______________________________________________ openwrt-devel 
> > mailing list openwrt-devel at lists.openwrt.org 
> > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
> > 
> _______________________________________________
> openwrt-devel mailing list
> openwrt-devel at lists.openwrt.org
> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel