[OpenWrt-Devel] [PATCH][ar71xx] Routerboard 951G Switch Fix
dhutchison at bluemesh.net
Sat Dec 13 18:42:03 EST 2014
The boot loader on these boards is routerboot. I do not know if routerboot provides a md like command or not.
Sent from my iPhone
> On Dec 13, 2014, at 1:01 AM, John Crispin <blogic at openwrt.org> wrote:
>> On 10/12/2014 22:33, Chris Green wrote:
>>> On Wed, Dec 10, 2014 at 01:40:42PM -0700, Davey Hutchison wrote:
>>> Fix pll_1000 value for eth0. Traffic would not flow from the eth0 interface.
>>> The new PLL enables delay, use ath79_setup_ar934x_eth_cfg to also enable
>>> Signed-off-by: Davey Hutchison <dhutchison at bluemesh.net>
>>> --- target/linux/ar71xx/files/arch/mips/ath79/mach-rb95x.c
>>> +++ target/linux/ar71xx/files/arch/mips/ath79/mach-rb95x.c
>>> @@ -199,6 +199,7 @@
>>> ath79_setup_ar934x_eth_cfg(AR934X_ETH_CFG_RGMII_GMAC0 |
>>> + AR934X_ETH_CFG_RXD_DELAY |
>>> ath79_register_mdio(0, 0x0);
>>> @@ -209,6 +210,7 @@
>>> ath79_init_mac(ath79_eth0_data.mac_addr, ath79_mac_base, 0);
>>> ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
>>> ath79_eth0_data.phy_mask = BIT(0);
>>> + ath79_eth0_pll_data.pll_1000 = 0x3e000000;
>> This needs to be in mach-rb2011.c as well.
> i will hopefully get round to looking at this today. first i could not
> find my rs232 usb keyspan thingy, then i failed to find the poe injector ..
> do these board have uboot ? if so the easiest way would be to enter
> uboot, start a tftp to make sure the network is configured and then use
> the md command to display the relevant register.
> openwrt-devel mailing list
> openwrt-devel at lists.openwrt.org
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
More information about the openwrt-devel