[OpenWrt-Devel] ar934x+ar8327v4

Chris Green cl at isbd.net
Fri Dec 5 16:49:22 EST 2014

On Fri, Dec 05, 2014 at 12:39:16PM -0700, David Hutchison wrote:
> Here is a test I did by setting up swconfig manually. As you can see I
> put ports 1 and 2 into vlangroup 1. Traffic from port 2 can ping
> which is a device on port 1. However eth0.1 which as
> address cannot ping device on port 1.
> Attached is the swconfig setup, and a dmesg.
> Here is the arp result as well:
> root at OpenWrt:/# arp -n
> IP address       HW type     Flags       HW address            Mask     Device
>      0x1         0x0         00:00:00:00:00:00     *        eth0.1
> I used to be able to do:
> root at OpenWrt:/# swconfig dev eth0 show
> Failed to connect to the switch
> root at OpenWrt:/# swconfig list
> Found: switch0 - ag71xx-mdio.0
> Do you not think this is an issue with ag71xx? Do you it is something
> in user-space?
Same on mine (except I have an eth1 which is the 10/100 that works

root at OpenWrt:~# swconfig dev eth0 show
Failed to connect to the switch. Use the "list" command to see which switches are available.
root at OpenWrt:~# swconfig list
Found: switch0 - ag71xx-mdio.0
Found: switch1 - eth1
root at OpenWrt:~# 

Chris Green
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org

More information about the openwrt-devel mailing list