[FS#4076] Last available version for Tp-Link Archer C9 v1 is 19.0.7.x
openwrt-bugs at lists.openwrt.org
Sun Oct 10 08:44:14 PDT 2021
THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.
A new Flyspray task has been opened. Details are below.
User who did this - Daniel (dchollet)
Attached to Project - OpenWrt/LEDE Project
Summary - Last available version for Tp-Link Archer C9 v1 is 19.0.7.x
Task Type - Build Failure
Category - Other
Status - Unconfirmed
Assigned To -
Operating System - All
Severity - Low
Priority - Very Low
Reported Version - Trunk
Due in Version - Undecided
Due Date - Undecided
Details - I have an old Tp-Link Archer C9 v1, WiFi does not work, but it has enough processing power and works fine as Firewall, Gateway, DNS/DHCP and VPN server on my network running Openwrt 19.0.7.x
Even when the Openwrt router page (https://openwrt.org/toh/hwdata/tp-link/tp-link_archer_c9_v1) points to a SpanShot build, it is missing under the bcm53xx\generic tree.
As I am using it actively as a firewall, would be good to have the possibility to compile and use newer versions. Contemporary routers like the NetGear R7000 or the Asus RTAC68U are supported on newer releases and even on SnapShot.
Please put the Archer C9 v1 back again on the tree.
Thanks in advance.
More information can be found at the following URL:
You are receiving this message because you have requested it from the Flyspray bugtracking system. If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.
More information about the openwrt-bugs