[FS#3812] WAVLINK WL-WN570HA1 low txpower activate amplifier via gpio

OpenWrt Bugs openwrt-bugs at lists.openwrt.org
Sat May 15 09:07:20 PDT 2021


THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - openwrt12345 (openwrt12345) 

Attached to Project - OpenWrt/LEDE Project
Summary - WAVLINK WL-WN570HA1  low txpower   activate amplifier via gpio
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - mittel
Priority - gering
Reported Version - All
Due in Version - Undecided
Due Date - Undecided
Details - **Device : WAVLINK WL-WN570HA1**

Firmwareversion : all  (19.07.7)

At this moment it is impossible to use the full txpower of the WN570HA1 on both bands (2,4Ghz and 5Ghz).
Possible txpower at the moment:
2,4 Ghz --->24dbm  (should have at least 27dbm)
5 Ghz ---> 11 dbm or 13 dbm (can`t remember right now)

Is it possible, that the device uses an external amplifier which has to be activated via gpio settings?

Referring to this post for the Asus Lyra 2200, could some sort of same method activate the amp in the WN570HA1 ?
https://forum.openwrt.org/t/asus-map-ac2200-low-transmit-receive-signal-5ghz/69005

I hope that one or two replies from more experienced users/programmers could lead us in the right direction.
Thanks in advance.

 

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3812

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.



More information about the openwrt-bugs mailing list