[FS#3692] Reduce fw3 warnings when both IPv4 and IPv6 are in use

OpenWrt Bugs openwrt-bugs at lists.openwrt.org
Fri Mar 19 20:17:31 GMT 2021


THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - Luiz Angelo Daros de Luca (luizluca) 

Attached to Project - OpenWrt/LEDE Project
Summary - Reduce fw3 warnings when both IPv4 and IPv6 are in use
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Low
Priority - Very Low
Reported Version - Trunk
Due in Version - Undecided
Due Date - Undecided
Details - When the same rule uses both IPv4 and IPv6 addresses, fw3 shows a bunch of warnings.


 * Populating IPv4 filter table
   * Rule 'xxx-UDP'
     ! Skipping due to different family of ip address
     ! Skipping due to different family of ip address
 * Populating IPv6 filter table
   * Rule 'xxx-UDP'
     ! Skipping due to different family of ip address
     ! Skipping due to different family of ip address


I suggest to remove that warning or only show it when the family is specified and it does not match.
There is no reason to show that when family is 'any'.

With too much noise, an important warning messaged might be missed.

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3692

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.



More information about the openwrt-bugs mailing list