[FS#3860] bcm53xx: Image Builder fails with "os-image partition too big" on Netgear R8000

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

The following task has a new comment added:

FS#3860 -  bcm53xx: Image Builder fails with "os-image partition too big" on Netgear R8000
User who did this - Nautilus Chan (NautilusChan)

----------
I had tried the same opeartion with v19.07.05. There was just a warining message:

nautilus at nautilus-ThinkPad-T440:/media/nautilus/Data/cycBackup/Router/openwrt/dev/20201215/openwrt-imagebuilder-19.07.5-bcm53xx.Linux-x86_64$ make image PROFILE=netgear-r8000
Building images for bcm53xx - Netgear R8000
Packages: base-files brcmfmac-firmware-43602a1-pcie busybox dnsmasq dropbear firewall fstools ip6tables iptables iwinfo kernel kmod-brcmfmac kmod-gpio-button-hotplug kmod-ipt-offload kmod-leds-gpio kmod-ledtrig-default-on kmod-ledtrig-timer kmod-phy-bcm-ns-usb2 kmod-phy-bcm-ns-usb3 kmod-usb-ledtrig-usbport kmod-usb-ohci kmod-usb2 kmod-usb3 libc libgcc logd mtd netifd nvram odhcp6c odhcpd-ipv6only opkg osafeloader oseama otrx ppp ppp-mod-pppoe swconfig uci uclient-fetch urandom-seed urngd wpad-basic
……
……
……
ubinize: volume size was not specified in section "rootfs", assume minimum to fit image "/media/nautilus/Data/cycBackup/Router/openwrt/dev/20201215/openwrt-imagebuilder-19.07.5-bcm53xx.Linux-x86_64/build_dir/target-arm_cortex-a9_musl_eabi/linux-bcm53xx/root.squashfs"2726794 bytes (2.6 MiB)
5325+1 records in
5325+1 records out
2726794 bytes (2.7 MB, 2.6 MiB) copied, 0.0135391 s, 201 MB/s
5325+1 records in
5325+1 records out
2726794 bytes (2.7 MB, 2.6 MiB) copied, 0.013486 s, 202 MB/s
mjn3's trx replacement - v0.81.1
WARNING: maxlen exceeds default maximum!  Beware of overwriting nvram!
5325+1 records in
5325+1 records out
2726794 bytes (2.7 MB, 2.6 MiB) copied, 0.0133649 s, 204 MB/s
mjn3's trx replacement - v0.81.1
WARNING: maxlen exceeds default maximum!  Beware of overwriting nvram!

Calculating checksums...


----------

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3860#comment9836

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.