[FS#3842] 802.11ac modulation out of place based on my 802.11n wireless mode (Attachment added)
openwrt-bugs at lists.openwrt.org
Wed Jun 2 08:27:43 PDT 2021
THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.
A new Flyspray task has been opened. Details are below.
User who did this - CyberHead (CyberHead)
Attached to Project - OpenWrt/LEDE Project
Summary - 802.11ac modulation out of place based on my 802.11n wireless mode
Task Type - Bug Report
Category - Kernel
Status - Unconfirmed
Assigned To -
Operating System - All
Severity - High
Priority - Very Low
Reported Version - openwrt-21.02
Due in Version - Undecided
Due Date - Undecided
Details - I have problems that disconnect clients, I use the 802.11n wireless mode and I have clients in which the ap puts VHT, losing communication without disconnecting, until the ap disconnects them due to inactivity.
My configuration, firmware and equipment data:
- Device problem occurs on my four APs, they use firmware snapshots and 21.02 rc-1
- Devices model: TP-Link EAP225-Outdoor v1
- Wireless mode "N"
- Channel width 20mhz
- wlan0 5GHz radio
One or more files have been attached.
More information can be found at the following URL:
You are receiving this message because you have requested it from the Flyspray bugtracking system. If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.
More information about the openwrt-bugs