[FS#3954] SATA Port Multiplier support

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - xt2six (xt2six) 

Attached to Project - OpenWrt/LEDE Project
Summary - SATA Port Multiplier support
Task Type - Build Failure
Category - Kernel
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Very Low
Priority - Very Low
Reported Version - openwrt-19.07
Due in Version - Undecided
Due Date - Undecided
Details - Supply the following if possible:

  * Target : x86 64 (all ?)
  * OpenWRT : 19.07.7
  * [[https://cateee.net/lkddb/web-lkddb/SATA_PMP.html|SATA Port Multiplier support]]

Impossible to see all my hard drive (I only see 4):

  * Marvell Technology Group Ltd. 88SE9235 PCIe 2.0 x2 4-port SATA 6 Gb/s Controller (rev 11)

Could you enable this option during kernel compilation please:

CONFIG_SATA_PMP=y


like in this target : [[https://github.com/openwrt/openwrt/commit/390c4df2c0b2e7b31c52eca3dcba139b0d745a97|mvebu: enable SATA port multiplier support]]

Thanks in advance, I'm stuck in mounting my router because of this

Cordially
   

 

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3954

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.