[FS#3642] ip2d fails to configure and run on install

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - Nigel Reed (nelgin) 

Attached to Project - OpenWrt/LEDE Project
Summary - ip2d fails to configure and run on install
Task Type - Bug Report
Category - Packages
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Medium
Priority - Very Low
Reported Version - openwrt-19.07
Due in Version - Undecided
Due Date - Undecided
Details - Supply the following if possible:
 - Device problem occurs on
 - Software versions of OpenWrt/LEDE release, packages, etc.
 - Steps to reproduce
   

Running on a Netgear R6220
Firmware OpenWrt 19.07.2 r10947-65030d81f3 / LuCI openwrt-19.07 branch git-21.054.03371-3b137b5

Using the LuCI web interface to install i2pd I received the postinstall messages.

mkdir: can't create directory '': No such file or directory
ln: /certificates/certificates: File exists
ln: /tunnels.conf: File exists
chown: : No such file or directory
chown: : No such file or directory

If I also try to start with service i2pd start then I get the same thing.


# service i2pd start
mkdir: can't create directory '': No such file or directory
ln: /certificates/certificates: File exists
ln: /tunnels.conf: File exists
chown: : No such file or directory
chown: : No such file or directory



More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3642

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.