[FS#3765] RT5592 initializes but does not function when enabled

[OpenWrt Bugs]

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - Michael Pratt (mcpratt) 

Attached to Project - OpenWrt/LEDE Project
Summary - RT5592 initializes but does not function when enabled
Task Type - Bug Report
Category - Kernel
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - High
Priority - Very Low
Reported Version - openwrt-21.02
Due in Version - Undecided
Due Date - Undecided
Details - this issue is also present on master branch

board is EPG600 (not added yet)
this probably also affects ESR600 which is the same hardware
and other boards with RT5592

5 GHz wireless initializes and SSID can be seen on scan
however, clients cannot connect and traffic fails


init:


...
...
[   12.654377] rt2800pci 0000:01:00.0: card - bus=0x1, slot = 0x0 irq=4
[   12.668538] rt2800pci 0000:01:00.0: loaded eeprom from mtd device "factory"
[   12.675676] ieee80211 phy0: rt2x00_set_rt: Info - RT chipset 5592, rev 0222 detected
[   12.683626] ieee80211 phy0: rt2x00_set_rf: Info - RF chipset 000f detected
[   12.711360] urngd: jent-rng init failed, err: 2
[   12.737471] rt2800_wmac 10180000.wmac: loaded eeprom from mtd device "rf"
[   12.744489] ieee80211 phy1: rt2x00_set_rt: Info - RT chipset 6352, rev 0500 detected
[   12.752435] ieee80211 phy1: rt2x00_set_rf: Info - RF chipset 7620 detected
...
...



iw list (phy0):


Wiphy phy0
        wiphy index: 0
        max # scan SSIDs: 4
        max scan IEs length: 2261 bytes
        max # sched scan SSIDs: 0
        max # match sets: 0
        Retry short long limit: 2
        Coverage class: 0 (up to 0m)
        Available Antennas: TX 0 RX 0
        Supported interface modes:
                 * IBSS
                 * managed
                 * AP
                 * AP/VLAN
                 * monitor
                 * mesh point
        Band 2:
                Capabilities: 0x2fe
                        HT20/HT40
                        SM Power Save disabled
                        RX Greenfield
                        RX HT20 SGI
                        RX HT40 SGI
                        TX STBC
                        RX STBC 2-streams
                        Max AMSDU length: 3839 bytes
                        No DSSS/CCK HT40
                Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
                Minimum RX AMPDU time spacing: 2 usec (0x04)
                HT TX/RX MCS rate indexes supported: 0-15, 32
                Frequencies:
                        * 5180 MHz [36] (20.0 dBm)
                        * 5190 MHz [38] (20.0 dBm)
                        * 5200 MHz [40] (20.0 dBm)
                        * 5210 MHz [42] (20.0 dBm)
                        * 5220 MHz [44] (20.0 dBm)
                        * 5230 MHz [46] (20.0 dBm)
                        * 5240 MHz [48] (20.0 dBm)
                        * 5250 MHz [50] (20.0 dBm) (no IR, radar detection)
                        * 5260 MHz [52] (20.0 dBm) (no IR, radar detection)
                        * 5270 MHz [54] (20.0 dBm) (no IR, radar detection)
                        * 5280 MHz [56] (20.0 dBm) (no IR, radar detection)
                        * 5290 MHz [58] (20.0 dBm) (no IR, radar detection)
                        * 5300 MHz [60] (20.0 dBm) (no IR, radar detection)
                        * 5310 MHz [62] (20.0 dBm) (no IR, radar detection)
                        * 5320 MHz [64] (20.0 dBm) (no IR, radar detection)
                        * 5500 MHz [100] (20.0 dBm) (no IR, radar detection)
                        * 5510 MHz [102] (20.0 dBm) (no IR, radar detection)
                        * 5520 MHz [104] (20.0 dBm) (no IR, radar detection)
                        * 5530 MHz [106] (20.0 dBm) (no IR, radar detection)
                        * 5540 MHz [108] (20.0 dBm) (no IR, radar detection)
                        * 5550 MHz [110] (20.0 dBm) (no IR, radar detection)
                        * 5560 MHz [112] (20.0 dBm) (no IR, radar detection)
                        * 5570 MHz [114] (20.0 dBm) (no IR, radar detection)
                        * 5580 MHz [116] (20.0 dBm) (no IR, radar detection)
                        * 5590 MHz [118] (20.0 dBm) (no IR, radar detection)
                        * 5600 MHz [120] (20.0 dBm) (no IR, radar detection)
                        * 5610 MHz [122] (20.0 dBm) (no IR, radar detection)
                        * 5620 MHz [124] (20.0 dBm) (no IR, radar detection)
                        * 5630 MHz [126] (20.0 dBm) (no IR, radar detection)
                        * 5640 MHz [128] (20.0 dBm) (no IR, radar detection)
                        * 5650 MHz [130] (20.0 dBm) (no IR, radar detection)
                        * 5660 MHz [132] (20.0 dBm) (no IR, radar detection)
                        * 5670 MHz [134] (20.0 dBm) (no IR, radar detection)
                        * 5680 MHz [136] (20.0 dBm) (no IR, radar detection)
                        * 5690 MHz [138] (20.0 dBm) (no IR, radar detection)
                        * 5700 MHz [140] (20.0 dBm) (no IR, radar detection)
                        * 5745 MHz [149] (20.0 dBm) (no IR)
                        * 5755 MHz [151] (20.0 dBm) (no IR)
                        * 5765 MHz [153] (20.0 dBm) (no IR)
                        * 5775 MHz [155] (20.0 dBm) (no IR)
                        * 5785 MHz [157] (20.0 dBm) (no IR)
                        * 5795 MHz [159] (20.0 dBm) (no IR)
                        * 5805 MHz [161] (20.0 dBm) (no IR)
                        * 5825 MHz [165] (20.0 dBm) (no IR)
                        * 4920 MHz [184] (disabled)
                        * 4940 MHz [188] (disabled)
                        * 4960 MHz [192] (disabled)
                        * 4980 MHz [196] (disabled)
        valid interface combinations:
                 * #{ managed, AP, mesh point }