[FS#3334] RouterBoard RB411 ethernet not detected

Sun Sep 13 05:08:32 EDT 2020

THIS IS AN AUTOMATED MESSAGE, DO NOT REPLY.

A new Flyspray task has been opened.  Details are below. 

User who did this - Alexandros C. Couloumbis (acoul) 

Attached to Project - OpenWrt/LEDE Project
Summary - RouterBoard RB411 ethernet not detected
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To - 
Operating System - All
Severity - Low
Priority - Very Low
Reported Version - Trunk
Due in Version - Undecided
Due Date - Undecided
Details - 
OpenWrt kernel loader for AR7XXX/AR9XXX
Copyright (C) 2011 Gabor Juhos 
Decompressing kernel... done!
Starting kernel at 80060000...

Linux version 5.4.65 (alex at aifnis) (gcc version 9.3.0 (OpenWrt GCC 9.3.0 r14533-90a50020b0)) #0 Sat Sep 12 06:40:13 2020
printk: bootconsole [early0] enabled
CPU0 revision is: 00019374 (MIPS 24Kc)
MIPS: machine is MikroTik RouterBOARD 493G
SoC: Atheros AR7130 rev 2
Initrd not found or empty - disabling initrd
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Zone ranges:
  Normal   [mem 0x0000000000000000-0x0000000001ffffff]
Movable zone start for each node
Early memory node ranges
  node   0: [mem 0x0000000000000000-0x0000000001ffffff]
Initmem setup node 0 [mem 0x0000000000000000-0x0000000001ffffff]
Built 1 zonelists, mobility grouping on.  Total pages: 8128
Kernel command line: console=ttyS0,115200 rootfstype=squashfs,jffs2
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes, linear)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes, linear)
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
mem auto-init: stack:off, heap alloc:off, heap free:off
Memory: 25064K/32768K available (4082K kernel code, 139K rwdata, 608K rodata, 2332K init, 185K bss, 7704K reserved, 0K cma-reserved)
NR_IRQS: 51
CPU clock: 300.000 MHz
clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 12741736309 ns
sched_clock: 32 bits at 150MHz, resolution 6ns, wraps every 14316557820ns
Calibrating delay loop... 199.68 BogoMIPS (lpj=399360)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
random: get_random_bytes called from 0x8052fc2c with crng_init=0
clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 7645041785100000 ns
futex hash table entries: 256 (order: -1, 3072 bytes, linear)
pinctrl core: initialized pinctrl subsystem
NET: Registered protocol family 16
PCI host bridge /ahb/apb/pcie-controller at 17010000 ranges:
 MEM 0x0000000010000000..0x0000000016ffffff
  IO 0x0000000000000000..0x0000000000000000
PCI host bridge to bus 0000:00
pci_bus 0000:00: root bus resource [mem 0x10000000-0x16ffffff]
pci_bus 0000:00: root bus resource [io  0x0000]
pci_bus 0000:00: root bus resource [??? 0x00000000 flags 0x0]
pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
pci 0000:00:12.0: [1260:3873] type 00 class 0x028000
pci 0000:00:12.0: reg 0x10: [mem 0x00000000-0x00000fff pref]
pci 0000:00:12.0: supports D1 D2
pci 0000:00:12.0: PME# supported from D0 D1 D2 D3hot
pci_bus 0000:00: busn_res: [bus 00-ff] end is updated to 00
pci 0000:00:12.0: BAR 0: assigned [mem 0x10000000-0x10000fff pref]
workqueue: max_active 576 requested for napi_workq is out of range, clamping between 1 and 512
clocksource: Switched to clocksource MIPS
NET: Registered protocol family 2
tcp_listen_portaddr_hash hash table entries: 512 (order: 0, 4096 bytes, linear)
TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear)
TCP: Hash tables configured (established 1024 bind 1024)
UDP hash table entries: 256 (order: 0, 4096 bytes, linear)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear)
NET: Registered protocol family 1
PCI: CLS 0 bytes, default 32
random: fast init done
workingset: timestamp_bits=30 max_order=13 bucket_order=0
squashfs: version 4.0 (2009/01/31) Phillip Lougher
jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
ar7100-usb-phy 18030000.usb-phy: phy reset is missing
ar7100-usb-phy: probe of 18030000.usb-phy failed with error -524
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
printk: console [ttyS0] disabled
18020000.uart: ttyS0 at MMIO 0x18020000 (irq = 10, base_baud = 9375000) is a 16550A
printk: console [ttyS0] enabled
printk: console [ttyS0] enabled
printk: bootconsole [early0] disabled
printk: bootconsole [early0] disabled
rb4xx-gpio mikrotik,rb4xx-gpio: DMA mask not set
rb4xx-nand mikrotik,rb4xx-nand: DMA mask not set
nand: device found, Manufacturer ID: 0xad, Chip ID: 0x76
nand: Hynix NAND 64MiB 3,3V 8-bit
nand: 64 MiB, SLC, erase size: 16 KiB, page size: 512, OOB size: 16
Scanning device for bad blocks
spi-nor spi0.0: pm25lv512 (64 Kbytes)
1 routerbootpart partitions found on MTD device spi0.0
Creating 1 MTD partitions on "spi0.0":
0x000000000000-0x000000010000 : "partitions"
5 routerbootpart partitions found on MTD device partitions
Creating 5 MTD partitions on "partitions":
0x000000000000-0x00000000b000 : "routerboot1"
0x00000000b000-0x00000000c000 : "hard_config"
0x00000000c000-0x00000000d000 : "bios"
0x00000000d000-0x00000000f000 : "routerboot2"
0x00000000f000-0x000000010000 : "soft_config"
libphy: Fixed MDIO Bus: probed
ag71xx 19000000.eth: missing mac reset
ag71xx: probe of 19000000.eth failed with error -524
ag71xx 1a000000.eth: missing mac reset
ag71xx: probe of 1a000000.eth failed with error -524
MikroTik RouterBOARD hardware configuration sysfs driver v0.05
MikroTik RouterBOARD software configuration sysfs driver v0.03
NET: Registered protocol family 17
8021q: 802.1Q VLAN Support v1.8
Freeing unused kernel memory: 2332K
This architecture does not have kernel memory protection.
Run /init as init process
init: Console is alive
init: - watchdog -
kmodloader: no module folders for kernel version 5.4.65 found
init: - preinit -
random: jshn: uninitialized urandom read (4 bytes read)
random: jshn: uninitialized urandom read (4 bytes read)
random: jshn: uninitialized urandom read (4 bytes read)
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
procd: - early -
procd: - watchdog -
procd: - watchdog -
procd: - ubus -
urandom_read: 2 callbacks suppressed
random: ubusd: uninitialized urandom read (4 bytes read)
random: ubusd: uninitialized urandom read (4 bytes read)
random: ubusd: uninitialized urandom read (4 bytes read)
procd: - init -
Please press Enter to activate this console.
kmodloader: no module folders for kernel version 5.4.65 found
urngd: v1.0.2 started.
random: crng init done
random: 2 urandom warning(s) missed due to ratelimiting

BusyBox v1.31.1 () built-in shell (ash)

  _______                     ________        __
 |       |.-----.-----.-----.|  |  |  |.----.|  |_
 |   -   ||  _  |  -__|     ||  |  |  ||   _||   _|
 |_______||   __|_____|__|__||________||__|  |____|
          |__| W I R E L E S S   F R E E D O M
 -----------------------------------------------------
 OpenWrt SNAPSHOT, r14533-90a50020b0
 -----------------------------------------------------
=== WARNING! =====================================
There is no root password defined on this device!
Use the "passwd" command to set up a new password
in order to prevent unauthorized SSH logins.
--------------------------------------------------
root at OpenWrt:/# 

More information can be found at the following URL:
https://bugs.openwrt.org/index.php?do=details&task_id=3334

You are receiving this message because you have requested it from the Flyspray bugtracking system.  If you did not expect this message or don't want to receive mails in future, you can change your notification settings at the URL shown above.